Installation Guide

AMERICAST
®
LIMITED LIFETIME WARRANTY
If an American-Standard Americast® brand product is found to be defective in
materials or workmanship, after inspection by an authorized American-Standard
representative, American-Standard will repair or, at its option, exchange the product for
a similar model. This warranty extends for the lifetime of the product, so long as it
remains in use in its original place of installation, except that the warranty applies to a
bathing vessel’s slip-resisting surface only for the first year after the product’s initial
installation.
This warranty applies only to the original purchaser and installation of these
products.
This warranty does not apply to whirlpool components or to faucets, drains,
mounting rims, grab bars or other accessories. If manufactured or supplied by
American-Standard, such whirlpool components and accessories are covered under
separate limited warranties.
This warranty does not apply to local building code compliance. Since local building
codes vary considerably, the purchaser of this product should check with a local
building or plumbing contractor to assure local code compliance before installation.
This warranty shall be void if the Americast® brand product has been moved from
its initial place of installation; if it has been subjected to faulty maintenance, abuse,
misuse, accident or other damage; if it was not installed in accordance with American-
Standard’s instructions; or if it was modified in a manner inconsistent with the product
as shipped by American-Standard.
American-Standard's option to repair or exchange the product under this warranty
does not cover any labor or other costs of removal or installation, nor shall American-
Standard be responsible for any other incidental or consequential damages
attributable to a product defect or to the repair or exchange of a defective
product, all of which are expressly excluded from this warranty. (Some states or
provinces do not allow the exclusion or limitation of implied warranties, so this exclusion
may not apply to you.)
This warranty gives you specific legal rights. You may have other statutory rights that
vary from state to state or from province to province, in which case this warranty does
not affect such statutory rights.
For service under these warranties, it is suggested that a claim be made through the
contractor or dealer from or through whom the product was purchased, or that a service
request (including a description of the product model and of the defect) be sent to the
following address:
In the United States:
AMERICAN STANDARD, INC.
P.O. Box 6820
Piscataway, New Jersey 08855
Attn: Director of Consumer Affairs
For residents of the United States, warranty information may also be obtained by
calling the following toll free number: [phone]
In Canada:
AMERICAN STANDARD, INC.
2480 Stanfield Road
Mississauga, Ontario Canada L4Y 1S2
Toll Free: [phone]
In Mexico:
IDEAL STANDARD, S.A. de C.V
Customer Service Manager
Planta Santa Clara,Via Morelos #330
Santa Clara Coatitla
Ecatepec de Morelos 55540,
Estado de Mexico, Mexico
Princeton
™
Bath
Installation Instructions
*
1527mm
(60-1/8)
762mm
(30)
TUB WIDTH
LEVELING SUPPORT
STRINGER 51 x 102mm
(2 X 4)
FRAMING INSTRUCTIONS
Note recess is 1527 x 813mm (60-1/8 x 32). Cut a 229 x 305mm (9 x 12) hole in sub
floor for drain, centered 362mm (14-1/4) as shown for below floor rough. Locate studs
as required, then ensure rough opening dimensions are proper and supports are plumb
and square.
*Install stringer as shown (346mm [13-5/8] for through the floor drain or
435mm [17-1/8] for above the floor drain.)
362mm
(14-1/4)
Introduction: Thank you for selecting American-Standard...products which
have been the benchmarks of fine quality for over 100 years. To help insure
that the installation process will proceed smoothly, please read these instructions
carefully before you begin. Also carefully unpack and examine your new plumbing
fixture.
2390.202
2392.202
2391.202
2393.202
Observe Local Plumbing and Building Codes
1
790043-400 (Rev. G )
229 x 305mm
(9 x 12) FLOOR
CUTOUT
FOR DRAIN
813mm
(32)
© American Standard Inc. 2002