Installation Guide

Observe Local Plumbing and Building Codes
FRAMING INSTRUCTIONS
2
1
SAVE FOR FUTURE USE
790041-400 Rev. P 3/17
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017
Princeton
®
Bath Models:
2394.202, 2395.202, 2396.202, 2397.202
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is
installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
Note recess is 1527 x 762mm (60-1/8 x 30"). Cut a 229 x 305mm (9 x 12") hole in sub floor for drain, centered 464mm (18-1/4")
as shown for below floor rough. Locate studs as required, then ensure rough opening dimensions are proper and supports are
plumb and square.
*
Install stringer as shown (346mm [13-5/8"] for through the floor drain or 435mm [17-1/8"] for above the floor drain.)
DRAIN
Install the overflow and drain assembly onto the tub
per manufacturer's instructions.
*
864mm (34")
TUB WIDTH
464mm
(18-1/4")
229 x 305mm
(9 x 12) FLOOR
CUTOUT
FOR DRAIN
762mm
(30")
FULL LENGTH LEVELING SUPPORT
STRINGER 51 x 102mm (2 x 4 x 5')
APPLY BEAD OF SILICONE CAULKING
TO TOP OF LEVELING SUPPORT
STRINGER BEFORE INSTALLING TUB
FOR 2394/2395 MODELS ONLY:
Apply 1/4" thick beads of silicone caulking in
location shown to account for out of level sub-floor.
813mm
(32")
254mm
(10")
1527mm
(60-1/8")
203mm
(8")
356mm (14")

Summary of content (12 pages)