Installation & Assembly

FOR CADET TOILETS:
FOR YORKVILLE TOILETS:
7301276-100 Rev. B
- 2 -
3-1
FLUSH TO
1/16" (16mm)
EXPOSED
CLOSET
FLANGE
CLOSET
BOLTS
168mm
(6-5/8")
PILOT
HOLES
4"
(102mm)
13-5/8"
(346mm)
Install closet bolts in flange
channel, turn 90°, and slide
into place 6" (152 mm) apart
and parallel to floor. (Use
putty to hold bolts in place if
necessary.) Brace under
flooring as needed and
drill two mounting pilot
holes as shown.
INSTALL CLOSET BOLTS
5-1
INSTALL TOILET ON FLANGE
a. Unplug waste opening and install toilet on closet flange so bolts
project through mounting holes.
b. Loosely install retainer washers and nuts. Side of washers marked
"THIS SIDE UP" must face up!
4-1
Install seal evenly around waste
flange (horn). Apply a thin bead
of sealant around base flange.
* Note: Wax seal not recommended for this application.
INSTALL NEOPRENE OR GRAPHITE FELT SEAL*
4-2
INSTALL WAX SEAL
NEOPRENE
SEAL
SEALANT
LAG
BOLT
TAPERED
WASHERS
FLANGE
FLANGE BOLTS
3-2
Install closet bolts in flange
channel, turn 90°, and slide
into place 6" (152 mm) apart
and parallel to wall.
INSTALL CLOSET BOLTS
305mm
(12)
CLOSET FLANGE
CLOSET BOLTS
5-2
INSTALL TOILET ON FLANGE
a. Unplug floor waste opening and install toilet on closet flange so bolts
project through mounting holes.
b. Loosely install retainer washers and nuts. Side of washers marked
"THIS SIDE UP" must face up!
CLOSET
BOLT
NUT
TAPERED
WASHER
FLANGE
WAX
RING
SEALANT
Invert toilet on floor (cushion
to prevent damage), and
install wax ring evenly around
waste flange (horn), with
tapered end of ring facing
toilet. Apply a thin bead of
sealant around base flange.
1
2