Installation Guide

SEAL
DECK MOUNT BATH FILLER
MOMENTS
Certified to comply with ANSI A112.18.1M
Recommended Tools
*Supplied with Fitting
*Hex key
Turn off hot and cold water
supplies before beginning.
CAUTION
1
Insert SPOUT SHANK (1) through center hole of MOUNTING SURFACE.
Important: Set screw slot in SPOUT SHANK (1) must face back of fitting. View A.
Install SPOUT ESCUTCHEON AND SEAL (5) onto SPOUT SHANK (1).
SPOUT AND VALVE ASSEMBLY
Flat Blade Screwdriver
Adjustable Wrench
Channel Locks
ROUGHING-IN DIMENSIONS
Installation
Instructions
2506.921
2506.920
Tubing Cutter
Sealing Tape
M968694 Rev.1.5
MOUNTING
SURFACE
7-7/8"
(200mm)
3-3/4"
(96mm)
9-7/8"
(250mm)
9-3/4"
(247mm)
1-3/8"
(35mm)
1-1/2 " MAX.
(38mm) MAX.
1-3/16" MAX.
(30mm) MAX.
1-3/16
" D.
(30mm) D.
3
"
(76mm)
(H)
(C)
1-1/8
" D.
2-3/8 " D.
(59mm)
12 " MAX.
(305mm)
1-1/16
" D.
(27mm) D.
3/4-14 MALE
N.P.S.M. INLETS
6-1/2" to 12"
(165mm to 305mm)
Thread MOUNTING RING NUTS (6) counter clock-wise to allow enough
space for the thickness of the mounting surface.
Adjust the three LOCKING SCREWS (7) so that they extend about 1/2 inch
above the MOUNTING RING NUTS (6). Install MOUNTING WASHERS (8) and
RUBBER WASHERS (9) onto VALVE BODIES. Thread VALVE BODY (10) with
red band into the left side (hot) of the VALVE ESCUTCHEON (11) until it’s
seated against the stop. Thread the (cold) VALVE BODY (10a) into the opposite
VALVE ESCUTCHEON (11).
Hand tighten the MOUNTING RING NUTS (6) on valve bodies.
Adjust valve outlets to face the SPOUT SHANK (1).
With a flate blade screwdriver alternetly tighten the three LOCKING
SCREWS (7) to secure the valve bodies. Make sure there is equal
pressure on all LOCKING SCREWS (7).
7
6
9
8
1-1/8'' MAX.
MOUNTING
SURFACE
DETAIL OF VALVE ASSEMBLY
11, 11a
1/2''
7
6
2
3
4
1
5
11
9
8
10
10a
RED BAND
INSTALL
VALVE OUTLET
SLOT
VIEW "A"
11
Assemble RUBBER WASHER (2) and BRASS WASHER (3) onto SPOUT SHANK (1).
From underside of ledge secure SPOUT SHANK (1) into position with LOCKNUT (4).
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
2-1/16
DIA.
7-7/8"
(200mm)