Installation Guide

PREPARATION:
Saver
™
bath tub walls are to be installed directly
over stud walls. Drywall is not required.
A) Remove dry wall surface and ensure that
alcove is plumb and square. (Illustration 1)
B) Identify your model number in the illustrations
which follow. Prepare studs as indicated.
754748-100 Rev. B
2
Illustration 1
Each alcove
stud must
be plumb
and square.
Installation for use with tub Model# 2647.202
The studs should be located as shown
to properly support walls. Provide additional
studs where illustrated. (below)
8-1/4"
(210mm)
8-1/4"
(210mm)
30"
(762mm)
6"
(152mm)
12"
(305mm)
60"
(1524mm)
9-1/4"
(235mm)
9-1/4"
(235mm)
10"
(254mm)
10"
(254mm)