Installation Instructions

7301967-100 Rev. C
- 2 -
BACK-TO-BACK INSTALLATION
Recommended fitting type for
back-to-back installations.
Depending upon your plumbing and venting conditions, the flow from the Cadet
®
PRO in a
back-to-back installation may create a vacuum on the system and draw water from the opposing
bowl. The National Standards Plumbing Code prohibits the use of a cross fitting for drainage as
throw over is possible. The code does approve a directional "Y" style fitting with proper venting to
direct the water downward and away from the other toilet.
Press firmly.
Wax Ring
(sold separately)
1 2
Turn Off Water Supply
Flush to remove
water from tank;
sponge remaining
water from
bowl before
removing toilet.
Clean Flange
Before You Start:
If Removing An Existing Toilet
!
Caution: If leaving floor flange
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed on chart under ROUGH-IN DIMENSION “A”, the BOWL HEIGHT is listed as DIMENSION “B”.
BOWL SHAPE
RIGHT HEIGHT
®
12" (305mm) 16-1/2" (419mm) 270AA 3717A 4021
ELONGATED 10" (254mm) 16-1/2" (419mm) 270AB 3717A 4019
RIGHT HEIGHT
®
12" (305mm) 16-1/2" (419mm) 270BA 3717B 4021
ROUND FRONT 10" (254mm) 16-1/2" (419mm) 270BB 3717B 4019
COMPACT RIGHT 12" (305mm) 16-1/2" (419mm) 270FA 3717F 4021
HEIGHT
®
ELONGATED 14" (356mm) 16-1/2" (419mm) 270FC 3717F 4019
ELONGATED 12" (305mm) 15" (381mm) 270CA 3717C 4021
10" (254mm) 15" (381mm) 270CB 3717C 4019
ROUND FRONT 12" (305mm) 15" (381mm) 270DA 3717D 4021
10" (254mm) 15" (381mm) 270DB 3717D 4019
ROUGH-IN
DIM. “A”
COMBO
MODEL
BOWL
MODEL
TANK
MODEL
BOWL HEIGHT
DIM. “B”
FINISHED WALL
FINISHED
FLOOR
SUPPLY
AS
REQ'D.
A