Installation Instructions

DRAIN INSTALLATION INSTRUCTIONS:
Slide the drain nuts and poly-vinyl washers onto the
overflow and drain tubes.
Assemble the overflow and drain tubes loosely to the
drain tee.
Note: The beveled edge of the washer and threaded side
of the nut must face the drain tee prior to assembly.
Dry mount the Overflow Assembly and Drain Shoe onto
tub as shown.
Note: DO NOT detach Drain Shoe Cable for any reason.
Cut Overflow Assembly Tube and Drain Shoe Tube ends
as necessary to achieve fit. Remove rough edges with
sandpaper prior to assembly.
DRAIN Step 1
TUB WALL
DRAIN SHOE
DRAIN TEE
OVERFLOW
ASSEMBLY
OVERFLOW & DRAIN SHOE TUBE
MUST EXTEND 1"-1.5"
INTO DRAIN TEE ENDS
2
754782-100 Rev. F 11/14
A. Set cover down in place and secure to the floor with
6 screws (not provided) through wood strip locations.
B. Apply foam tape to outside top edge, even with the
top edge. Trim away excess gasket.
2
SCREW HERE
FOAM
3
A. Assemble drain to tub per instructions below.
INSTALLATION INSTRUCTIONS:
A. Set up the cover in the desired location. Locate
the drain outlet location and supply line locations
for the faucet (see faucet instructions).
B. Recommend cutting floor cutout - 10" x 5-5/8"
(254mm x 143mm) use cover as guide, as shown
in rough-in detail.
C. Mark lines on the floor for the cover location. Use
these to relocate cover.
D. Turn the cover over and apply silicone caulking to
the bottom of the cover as shown.
1