Installation Guide

DRAIN INSTALLATION INSTRUCTIONS:
Slide the drain nuts and poly-vinyl washers onto the overflow and drain tubes.
Assemble the overflow and drain tubes loosely to the drain tee.
Note: The beveled edge of the washer and threaded side of the nut must
face the drain tee prior to assembly.
Dry mount the Overflow Assembly and Drain Shoe onto tub as shown.
Note: DO NOT detach Drain Shoe Cable for any reason. Cut Overflow
Assembly Tube and Drain Shoe Tube ends as necessary to achieve fit.
Remove rough edges with sandpaper prior to assembly.
DRAIN Step 1
TUB WALL
DRAIN SHOE
DRAIN TEE
OVERFLOW
ASSEMBLY
OVERFLOW & DRAIN SHOE TUBE
MUST EXTEND 1"-1.5"
INTO DRAIN TEE ENDS
2
754782-100 Rev. 8 7/19
Install Overflow Assembly (H) using supplied Round Gasket (E),
Flange Ring (F) and Brass Overflow Nut (G).
Finger tighten Brass Overflow Nut (G).
Note: Brass Overflow Nut (G) to be tightened further upon
completion of Step 4.
DRAIN Step 2
DRAIN Step 3
Install Drain Shoe (D) using supplied brass Drain Bolt (A), Strainer (B)
and Gasket (C) as illustrated. Tighten Drain Bolt (A) to secure.
Do not overtighten or Drain Shoe assembly may be damaged.
Note: The top tub lip MUST be level. Verify top and bottom tub
floor sealing surfaces are clean, flat and smooth prior to assembly.
BRASS DRAIN BOLT
STRAINER
VERIFY STRAINER
IS LEVEL & FLUSH
WITH TUB SURFACE
TUB FLOOR
GASKET
DRAIN SHOE
A
B
C
D
SILICONE CAULK
REQUIRED
H
E
F
G
TUB WALL
ROUND GASKET
BRASS OVERFLOW NUT
ROUND FLANGE RING
OVERFLOW
ASSEMBLY
DRAIN Step 4
DRAIN Step 5
Verify Poly-Vinyl Washers (I) are installed under Drain Nuts
(beveled side inward). Tighten Drain Nuts to secure Drain Tee.
Finally, tighten Brass Overflow Nut (J) with an adjustable wrench
to secure Overflow. Do Not Overtighten!
Install Drain Knob over Overflow Shaft (set screw against
flat surface). Then adjust Knob for a 1/16"-1/8" wall gap as
illustrated. Finally, tighten set screw to secure.
CAUTION: Drain Knob wall gap is mandatory to allow
water to escape, preventing overflows.
TUB FLOOR
DRAIN SHOE
DRAIN TEE
DRAIN
NUTS
OVERFLOW
ASSEMBLY
VERIFY POLY-VINYL
WASHERS ARE INSTALLED
UNDER DRAIN NUTS
J
BRASS OVERFLOW NUT
I
!
MANDATORY DRAIN KNOB WALL GAP
1/16"-1/8"
3/32" ALLEN WRENCH