Installation Guide

755043-100 Rev. A

Operation: SYSTEM I WHIRLPOOL

BATHING:

• Fill bath with water at a comfortable bathing temperature - If your whirlpool is equipped with the optional

EZ-Heater, it will automatically maintain the water temperature.

• IMPORTANT: Do not fill the whirlpool more than 2/3 full before getting in, as it may overflow.

• IMPORTANT: Do NOT add bath oils or salts – this will damage the whirlpool pump.

• IMPORTANT: Water level must be at least one inch (25mm) above the highest jet before the whirlpool is

started. Operating the system without water (dry running) for extended periods will cause

pump damage and void the warranty.

STARTING WHIRLPOOL:

• Press on/off button to start whirlpool.

STOPPING WHIRLPOOL:

• Press on/off button again to stop whirlpool.

AIR VOLUME CONTROL ADJUSTMENTS:

• Water turbulence is determined by the amount of air mixed with the water. Rotate the air volume control

counterclockwise for more turbulence--clockwise for less.

FLOW JET VOLUME ADJUSTMENTS:

• The water flow action may be adjusted from vigorous to soft by rotating the nozzle clockwise for vigorous

massage and counter-clockwise for soft massage.

MORE VIGOROUS MASSAGE

(clockwise)

SOFTER MASSAGE

(counterclockwise)

MORE AIR LESS AIR