Instructions / Assembly

751733-100 Rev. H

Operation: SYSTEM I WHIRLPOOL with CHROMATHERAPY

BATHING:

• Fill bath with water at a comfortable bathing temperature - If your whirlpool is equipped with the

optional EZ-Heater, it will automatically maintain the water temperature.

• IMPORTANT: Do NOT fill the whirlpool more than 2/3 full before getting in, as it may overflow.

• IMPORTANT: Do NOT add bath oils or salts – this will damage the whirlpool pump.

• IMPORTANT: Water level must be at least one inch (25mm) above the highest jet before the whirlpool is started

Operating the system without water (dry running) for extended periods will cause pump damage and void the warranty.

OPERATING WHIRLPOOL and CHROMATHERAPY SYSTEM:

AIR VOLUME CONTROL ADJUSTMENTS:

Water turbulence is determined by the amount of air mixed

with the water. Rotate the air volume control counterclockwise for more turbulence, and clockwise for less.

FLOW JET VOLUME ADJUSTMENTS: Water flow-levels can be adjusted from vigorous to soft by rotating

the nozzle counterclockwise for vigorous and clockwise for soft.

Whirlpool

Air On/Off

Select “Light” mode

Lights On/Off

Change “Down”

to previous color

Change “Up” to

next color

Color Cycle

Function

WHIRLPOOL CONTROL:

Press this button to turn whirlpool pump on or off.

LIGHTS CONTROL:

Press this button to turn chromatherapy lights on or off.

UP:

Press this button to change “up” to the next color.

DOWN:

Press this button to change “down” to the previous color.

WAVE/CYCLE FUNCTION:

Press this button to start the cycle function (button will light).

Light color will continuously cycle through the spectrum.

Press again to exit cycle function (button light will go out).

FAVORITE COLOR – If you stop the Cycle Function on a particular color, the

system will automatically return to this color the next time it is used.