Installation & Assembly

ManualsBrandsAmerican Standard ManualsToiletsAmerican Standard Glenwall 1.28 GPF Wall Mounted Two Piece Elongated Chair Height Toilet - Less Seat

SAVE FOR FUTURE USE

7302395-100 Rev. 1 11/20

Product names listed herein are trademarks of AS America, Inc.

2882 SERIES

Glenwall

VorMax

Wall-mounted Toilet

INSTALLATION INSTRUCTIONS

CAUTION: PRODUCT IS FRAGILE. TWO PEOPLE ARE RECOMMENDED FOR HANDLING TO AVOID

BREAKAGE AND POSSIBLE INJURY!

NOTE: For proper operation product requires a minimum of 30 psi working line pressure

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed

properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be

sure your installation conforms to local codes.

RECOMMENDED TOOLS AND MATERIALS

Pictures may not exactly define contour of china

EZ-INSTALL KIT INCLUDED WITH TANK

Attachment Handle

Nuts (3)

When installed so top of seat is 17" to 19" (432mm to 483mm) from the nished oor. MEETS THE AMERICANS WITH DISABILITIES ACT

GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USEABLE BUILDING FACILITIES - CHECK LOCAL CODES.

FINISHED WALL

29-1/2"

(750mm)

9-5/8"

(245mm)

18-7/16"

(469mm)

14-5/8"

(372mm)

(229mm)

17-13/16"

(453mm)

7-1/2"

(191mm)

(102mm)

1-3/4"

(45mm)

5-1/8"

(130mm)

17"

(432mm)

C/L OF WASTE OUTLET

3-1/4"

(83mm)

5-1/4"

(133mm)

4-1/8" (105mm)

C/L OF SEAT POST

HOLES 5-1/2"

(140mm CENTERS)

3-7/8"

(98mm)

SUPPLY AS

REQUIRED

32-13/16"

(833mm)

*7-1/2"

(191mm)

*8-1/2"

(216mm)

BACK-TO-BACK INSTALLATION

Recommended fitting type for

back-to-back installations.

Depending upon your plumbing and venting conditions, the

flow from the toilet in a back-to-back installation may create

a vacuum on the system and draw water from the opposing

bowl. The National Standards Plumbing Code prohibits the

use of a cross fitting for drainage as throw over is possible.

The code does approve a directional "Y" style fitting with

proper venting to direct the water downward and away from

the other toilet.

Closet Carrier Support

Putty Knife

Regular Screwdriver

Adjustable Wrench

Sealant

Tape Measure

Carpenters Level

Water Supply Line - Verify length required

STANDARD

BOLT CAP

CHINA / TOILET

WALL

RETROFIT

BOLT CAP

WALL

CHINA / TOILET

STANDARD BOLT CAP

RETROFIT BOLT CAP

NOTE: If carrier bolt does not extend

or is flush with china, use

retrofit caps 7381285-200.0070A

(sold separately).

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Glenwall® VorMax® Wall-mounted Toilet 2882 SERIES When installed so top of seat is 17" to 19" (432mm to 483mm) from the finished floor. MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USEABLE BUILDING FACILITIES - CHECK LOCAL CODES. Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin.
PAGE 2
FIXTURE MOUNTING Fixture studs should project 58mm (2-1/4") from face of finished wall. FINISHED WALL 2-1/4" (58mm) (4) CARRIER BOLTS FRONT VIEW SIDE VIEW 3 Place back-up nuts on both bottom bolts, and the top left-hand bolt only. Adjust the two lower back-up nuts so that front face of nuts and washers are positioned to allow a minimum 1/16" (2mm) gap between fixture and wall surface.
PAGE 3
9 Water Level Adjustment Knob Trip Lever Rod Overflow Tube Approximate Water Level Float Cup Adjustable Screw Fill Valve Or Water Control A B C Adjust water level to level indicated on tank by turning water level adjustment knob to move float cup up or down. Prime the system by flushing the product 5 times before use to achieve optimal performance. Water Supply Line PROPER FLUSHING METHOD: Be sure to fully depress the trip lever on each flush.
PAGE 4
IMPORTANT: American Standard does not recommend that the tank components be switched out with anything other than the furnished specified components as the performance could be affected. Any alterations made using anything other than the specified components could negatively impact the flush performance and will void the warranty. CARE AND CLEANING When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry with a soft cloth. WARNING: Do not use in-tank cleaners.