Instructions / Assembly

7301416-100 Rev. L 1/16
6
8
7
INSTALL TOILET
a. Position toilet squarely to wall and, with a rocking motion, press bowl
down fully on wax ring and flange. Alternately tighten nuts until toilet
is firmly seated on floor.
CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b. Install caps on washers. (If necessary, cut bolt height to size before
installing caps.)
c. Smooth off the bead of sealant around base. Remove excess sealant.
INSTALL TANK
a. Insert rubber grommets through holes in the tank then
insert bolts through holes in the grommets.
b. Install large rubber gasket over threaded outlet on bottom
of tank and lower tank onto bowl so that tapered end of
gasket fits evenly into bowl water inlet opening.
c. With tank parallel to wall, alternately tighten nuts until tank
is snugged down evenly against bowl surface.
INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.
CLOSET FLANGE
CLOSET BOLT
NUT
WASHER
BOLT CAP
!
- 2 -
CAUTION:
DO NOT OVERTIGHTEN NUTS MORE
THAN REQUIRED FOR A SNUG FIT!
9a 9b
Before continuing, determine the type of water supply connection you have from the chart below
and use the appropriate assembly parts required to properly reconnect the water supply.
CAUTION: DO NOT USE
CONE WASHER WITH
PLASTIC SUPPLY LINE.
These parts must be used as
illustrated to ensure water-tight
connection. Use of existing
coupling nut may result in water
leakage. Water supply tube or
pipe must extend at least 1/2"
inside threaded shank of valve
(does not apply to flanged tubing).
Use existing coupling
nut and washer.
Use existing spiral cone
washer. Fluidmaster cone
washer may not seal
completely on spiral type
supply line.
Captive cone washers
already included. No
additional washers needed.
CAUTION: Overtightening of LOCK
NUT or COUPLING NUT could result
in breakage and potential flooding.
METAL / COPPER
FLARED TUBING
METAL FLANGED
TUBING
METAL SPIRAL
TUBING
VINYL / BRAIDED
CONNECTOR
LOCK NUT
LOCK NUT
LOCK NUT
LOCK NUT
COUPLING
NUT
COUPLING
NUT
EXISTING
COUPLING
NUT
COUPLING
NUT
WATER
SHUT-OFF
WATER
SHUT-OFF
WATER
SHUT-OFF
WATER
SHUT-OFF
CONE
WASHER
EXISTING
CONE
WASHER
EXISTING
WASHER
!
!
WARNING: Do not use plumber’s putty, pipe dope, or any other sealant on the water supply
connection to this tank. If the connection leaks after hand tightening, replace the supply line. If
the connection continues to leak with the new supply line, replace the fill valve.
Warranty is void if any type of sealant is used on the water supply connection.
With correct washers in place (see
Step 9a), tighten COUPLING NUT
1/4 turn beyond hand tight.
DO NOT OVERTIGHTEN.
RUBBER
GASKET
TANK MTG.
BOLTS
WASHER/NUT
RUBBER
GROMMET