Installation Guide

- 3 -

755578-100 Rev. B 7/18

Illustration 6

Illustration 7

Install the shower door or shower curtain rod according to the manufacturer’s instructions.

APPLYING SEALANT AND INSTALLING SHOWER HANDLE AND SHOWER HEAD

1) Allow 24 hours for the wall panel adhesive to dry before applying the sealant as shown.

2) Apply a bead of sealant around all corners, outside edges of panels, corner panels

and deck of tub.

See Illustration 7

3) Install the shower handle and shower head per the manufacturer’s instructions. Be

sure to apply sealant to all trim plates.

Note – allow 24 hours for the sealant to dry before use.

INSTALLING THE CORNER PANELS

1) Place corner panel into rear corner of shower and check for proper fit of corner panel to shower walls. Ensure corner panels

completely overlap both rear and side panels by at least 1/4" (6mm).

2) Apply adhesive to one rear corner at a time (as illustrated) top to bottom, side to side and on back of the corner panel and

place into rear corner of shower. Press firmly to hold in place.

See Illustration 6

NOTE: It may be necessary to brace or support the corner panel in position until the adhesive drys. Use cloth under any

support to prevent any marring of the walls finished surface.

3) Wipe the panel down with a damp rag while continuing to apply pressure to the panel to ensure it makes complete contact.

NOTE – WIPE ANY EXCESS ADHESIVE FROM THE PANEL WITH A DAMP RAG OR MINERAL SPIRITS

Apply sealant

along the back