Installation Guide

754818-100 Rev. A

OWNER’S MANUAL

1. Enter your American Standard

walk-in bath, close the door, place handle in down position, and fill the bath

to at least 2 inches above the highest jet before activating the whirlpool pump (if equipped). Do not apply

excessive pressure when placing the handle in the close position. Do not put weight on the door when

entering and exiting the tub. It is recommended to leave the door in the open position when the tub

is not in use.

2. If your American Standard

walk-in bath is equipped with Whirlpool Jets, Air Spa, or Combo system, the pump

or blower is operated by the push button switch labeled “Jets” or “Air”. Both the number of buttons and their

assorted functions vary. Do not depress the button(s) repeatedly and/or rapidly as all function(s) are controlled

electronically. It may take a few seconds before any change becomes perceptible. Refer to massage

instructions sheet for more information on the controls.

3. If your American Standard

walk-in bath is equipped with whirlpool jets, you can adjust the direction and flow

rate of the jets to your liking by moving the nozzle for direction and turning the outside ring or the nozzle

clockwise or counterclockwise for the flow rate. Some jets are notadjustable at the jet face, but can be

adjusted by the “Legs Only Massage” valve located near the seat. (If equipped.)

. The Legs Only Massage (whirlpool & combo systems only) opens and closes the jets above the seat which

allows you to fill the tub half-way and operate only the lower whirlpool jets. The Legs Only Massage valve

must be closed when filling the tub half-way and operating the whirlpool. Failure to close the valve, when filling

the tub half-way will result in water shooting out of the jets above the seat when the pump is activated.

(If equipped.)

5. If your American Standard

walk-in bath is equipped with an Air Spa system, you can activate the heated

blower by pushing the push button on the deck. Push the button to turn on / off and cycle for the

various speeds.

6. If your American Standard

walk-in bath is equipped with an in-line heater, the heating element will come on

automatically, but only when the whirlpool system is turned on. This heater is designed to extend the

comfortable bathing time, but does not reheat the bath water.

7. If your American Standard

walk-in bath is equipped with the Automatic Tub Clean System - Ozone, the

system will turn on automatically when the whirlpool system is turned on.

8. If your American Standard

walk-in bath is equipped with the Quick Drain

, this system has its own

dedicated pump, suction and switch to activate the drain. Simply open the traditional drain system

(turn the overflow) and then press the Quick Drain

on/off switch to activate the drain. When the

water falls below the suction guard, press the control switch to turn the drain system off.

SAVE THESE INSTRUCTIONS! OPERATING INSTRUCTIONS