Installation Guide

754818-100 Rev. A

OWNER’S MANUAL

WHIRLPOOL PUMP

MOTOR WILL NOT START – CHECK FOR:

• Check the air line between the motor and air button for connection and depress to test air signal.

• Improper or loose connections, open switches or relays, blown circuit breakers.

• Manually check rotation of motor shaft for free movement and obstruction.

MOTORS CUTS OUT – CHECK FOR:

• Wiring, loose connections etc.

• Low Voltage at motor. (Frequently caused by undersized wiring.)

• Binding or overload. (Amperage Reading.)

MOTOR HUMS, BUT WILL NOT PRIME. –CHECK FOR:

• Make sure all suction, discharge lines and valves are open and un-obstructed.

• Check for correct water level.

• Block off suction and determine if pumps develops a vacuum. If pump develops a vacuum check

discharge line for obstruction or a leak in the suction line.

• If the pump does not develop a vacuum and the pump has the correct water level, check for proper

voltage and / or check the pump wet end for clogging or debris

AIR MASSAGE

MOTOR WILL NOT START – CHECK FOR:

• Check the air line between the motor and air button for connection and depress to test air signal.

• Improper or loose connections, open switches or relays, blown circuit breakers.

• Manually check rotation of motor shaft for free movement and obstruction.

MOTORS CUTS OUT – CHECK FOR:

• Verify if the air supply line from the blower to the manifold is connected and not obstructed.

• Wiring, loose connections etc.

• Low Voltage at motor. (Frequently caused by undersized wiring.)

CHROMATHERAPY LIGHTS

LIGHTS WILL NOT OPERATE – CHECK FOR:

• Check the air line between the motor and air button for connection and depress to test air signal.

• Wiring and /or loose connections etc

• Improper or loose connections, open switches or relays, blown circuit breakers.

TROUBLE SHOOTING GUIDELINES

(continued)