Installation Guide

OWNERS MANUAL
10
Alcove Installation
`
Drain Overflow
Faucet and Pump
Access Panels
IMPORTANT
Do not use tile flange to
screw or nail tub in place.
Tubs installed in an alcove installation require a raised flange to prevent water from seeping past the tub and into the wall. Tubs
without a raised flange shall be installed with a tile flange kit such as model: 9FLNG or a similar type. The flange kit is a long
plastic strip that is fits onto the rim of the tub to provide the leak protection needed.
The tile flange should be installed on the tub before it is placed in the alcove. Install the tile flange along all sides of the tub where
the wall will be. Measure to fit and miter cut the flange corners. The flange should be attached to the tub with a silicone adhesive.
Warnin
g
:
N
ever attem
p
t to nail or screw thru the tub as this will result in
p
roduct failure and will void the warrant
y
.
Non Integral Flange
Integral Flange
Model A B C D E F G
2651.11X
50 ½” 26 ¼” 37 ½” 9 ½” 11 ½” 15 ½” N/A
2848.10X
48” 28” 38” 10 ¾” 14” 16 ¾” N/A
2848.11X
48” 28” 37 ½” 10” 14½” 16” N/A
3051.11X
50 ½” 30 ½” 37 ½” 9 ½” 14½” 15 ½” N/A
3052.10X
51 ½” 29 ¾” 42” 12 ½” 14½” 17” N/A
3151.10X
50 ½” 31 ¼” 37 ½” 10” 14 ½” 15 ¾” 38”
3060.10X
59 ½” 29 ¾” 37 ½” 31 ¼” 14½” 15 ¼” 38”
3260.21X
59 ½” 32 37 11 ½” 16” 20½” N/A