Instructions / Assembly

Overflow with Quick Drain
Connection of the
Quick Drain
1. Installation of the Quick
Drain System requires the connection to a minimum 1 ½” sanitary drain line.
2. Use only SCH 40 1-1/2” diameter pipe and fittings; use approved PVC primer and glue.
The Sanitary Tee from the Quick Drain should be installed directly above the Drain Tee.
3.
4. There should be a maximum of 1” of 1-1/2” PVC pipe between the two Sanitary Tees.
5. Dry fit the drain/overflow assembly to the sanitary drainage pipe and check for proper fit.
6. Glue the Quick
Drain fittings, pipe, and drain overflow assembly to the sanitary drainage pipe.
Drain
Over Flow
Flow Direction
P-Trap
Drain Shoe
Nut
Strainer
Gasket
Stopper
Drain
Cable
Drain
Cable
From Quick
Drain Pump
Manifold
To Check Valve
ST 90 Elbow
Reducer 1-1/2” x 1”
Sanitary Tee
Subfloor
Sanitary Tee
(Drain Tee)
Pre-Installed Back Flow Manifold
Supplied
Not Supplied
We have taken reasonable precautions to ensure the Quick Drain is suitable for residential plumbing, it is the
responsibility of the installer to insure that the plumbing is acceptable for use of the Quick Drain. We do not
accept responsibility for damage arising from the use of the
Quick Drain.
• Please verify compliance with local and state code requirements for the installation.
• Do not change or modify the location and / or piping connection of the Back Flow Manifold.
• Installation of the Quick Drain System req
uires the connection to a minimum 1 ½” sanitary drain line.
• Use an approved Schedule 40 PVC Pipe, PVC Primer, and PVC Glue for sanitary pipe applicat
ions.
•
Pre-assemble the waste / overflow assembly per installation instructions.