Installation Guide

SINGLE CONTROL

KITCHEN PULL-DOWN FAUCET

4005 Series

Thank you for selecting American-Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--

please read these instructions carefully before you begin.

Installation

Instructions

Certiﬁed to comply with ANSI A112.18.1M

INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON

PUTTY

SPOUT BASE

SEAL

SINK OR

MOUNTING

SURFACE

SPOUT BASE

Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside

of sink or mounting surface. Hand tighten LOCKNUT (6).

Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening

the screws slightly each time until all are snug to ensure even pressure.

(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1).

Insert SUPPLY HOSES (2), SPRAY HOSE (9) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and

mounting surface. Follow mounting instructions below to secure faucet to mounting surface.

(B) Installation less ESCUTCHEON (1). Discard ESCUTCHEON with PUTTY PLATE (1). Insert supply HOSES (2), SPRAY

HOSE (9) and SHANK (3) through mounting hole and seat SPOUT BASE onto sink or mounting surface. Do not use putty.

Plumbers' Putty or Caulking

Adjustable Wrench

Phillips Screwdriver

RECOMMENDED TOOLS

Regular Screwdriver

9 9

Insert HOSES (2) through RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6).

Turn off water at

main supply.

CAUTION

FAIRBURY

M968679 Rev. 1.3

PAGE 1
Installation Instructions 4005 Series FAIRBURY SINGLE CONTROL KITCHEN PULL-DOWN FAUCET Thank you for selecting American-Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M M968679 Rev. 1.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. 2 1 Faucet supplies are 21" long from faucet base.
PAGE 3
5 CHECK CONNECTIONS FOR LEAKS. Move HANDLE down into "off" position. Turn on water supplies and check connections for leaks. Operate HANDLE (2) up and down, left and right to flush water lines thoroughly. Operate HAND SPRAY and check connections for leaks. CHECK CONNECTIONS FOR LEAKS 6 SERVICE If faucet drips, operate HANDLE several times from "off" to "on." Do not apply excessive force. Clogged CARTRIDGE outlets or inlets may cause reduced flow.