Installation Guide

7301276-100 Rev. B
- 3 -
10
9
ADJUSTMENTS
The flushometer tank is designed
and factory-adjusted to provide a
consistent, safe seal depth in the
bowl after each flush. Field refill
adjustment is not required. The
refill has been preset and locked.
Before continuing, determine the type of water supply connecation you have from the chart
below and use the appropriate assembly parts required to properly reconnect the water supply.
DO NOT use plumber's putty to seal these fittings.
CAUTION: DO NOT USE
CONE WASHER WITH
PLASTIC SUPPLY LINE.
These parts must be used as
illustrated to insure water-tight
connection. Use of existing
coupling nut may result in water
leakage. Water supply tube or pipe
must extend at least 1/2" inside
threaded shank of valve (does not
apply to flanged tubing).
Use existing
coupling nut
and washer.
Use existing spiral
cone washer.
Fluidmaster cone
washer may not seal
completely on spiral
type supply line.
Captive cone washers
already included. No
additional washers needed.
CAUTION: Overtightening of
LOCK NUT or COUPLING NUT
could result in breakage and
potential flooding.
METAL/COPPER
FLARED TUBING
METAL FLANGED
TUBING
METAL SPIRAL
TUBING
VINYL/BRAIDED
CONNECTOR
LOCK NUTLOCK NUT
LOCK NUT
LOCK NUT
COUPLING
NUT
COUPLING
NUT
EXISTING
COUPLING
NUT
COUPLING
NUT
WATER
SHUT-OFF
WATER
SHUT-OFF
WATER
SHUT-OFF
WATER
SHUT-OFF
CONE
WASHER
EXISTING
CONE WASHER
EXISTING
WASHER
FOR CADET TOILETS:
FOR YORKVILLE TOILETS:
7
8
a. Install large rubber gasket over threaded outlet on
bottom of tank and lower tank onto bowl so that
tapered end of gasket fits evenly into bowl water inlet
opening, and tank mounting bolts go through
mounting holes. Secure with metal washers and nuts.
b. With tank parallel to wall, alternately tighten nuts until
tank is snugged down evenly against bowl surface.
CAUTION: DO NOT OVERTIGHTEN
NUTS MORE THAN REQUIRED
FOR A SNUG FIT!
!
SPONGE
WASHER
TANK MTG.
BOLTS
NUT
WASHER
6-1
INSTALL TOILET
a. Position toilet squarely to wall and, with a rocking motion, push
bowl against ring and flange. Alternately tighten nuts until toilet is
firmly anchored.
CAUTION: DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b. Insert the tapered washers (supplied in the kit) into the lag bolts
(not supplied). Insert bolts through mounting holes and tighten into
pre-drilled floor openings.
c. Install the four bolt caps on tapered washers. (If necessary, cut wall
bolt length to size before installing caps.)
d. Smooth off the bead of sealant around base.
Remove excess sealant.
!
BOLT
HEAD
WASHER
BOLT
CAP
BOLT
CAP
NUT & WASHER
6-2
INSTALL TOILET
a. Position toilet squarely to wall and, with a rocking motion, press
bowl down fully on wax ring and flange. Alternately tighten nuts
until toilet is firmly seated on floor.
CAUTION: DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b. Install caps on washers. (If necessary, cut bolt height to size
before installing caps.)
c. Smooth off the bead of sealant around base.
Remove excess sealant.
!
CLOSET
BOLT
NUT
WASHER
BOLT CAP
CLOSET FLANGE
1
2
INSTALL TANK
INSTALL TOILET SEAT
Install toilet seat in accordance
with manufacturer's directions.