Installation Guide

Hand Tighten Only.

Do Not Overtighten.

7301555-100 Rev. 3 3/20

- 2 -

Turn Off Water Supply

Flush to remove

water from tank;

sponge remaining

water from

bowl before

removing toilet.

Clean Flange

Caution: If leaving floor flange

open for more than 1-2 hours,

cover flange to prevent escaping

sewer gases.

BACK-TO-BACK INSTALLATION

Recommended fitting type for

back-to-back installations.

Depending upon your plumbing and venting conditions, the flow from the toilet in a back-to-back

installation may create a vacuum on the system and draw water from the opposing bowl. The

National Standards Plumbing Code prohibits the use of a cross fitting for drainage as throw over

is possible. The code does approve a directional "Y" style fitting with proper venting to direct the

water downward and away from the other toilet.

4 5 6

TIP: Place 2 pieces of masking

tape on floor (as shown) to help

with alignment in step 4.

2 3

Before You Start:

If Removing An Existing Toilet

Apply weight evenly. Do not move after

placement. Water tight seal may break.

Tank-to-Bowl Gasket

Place the tank gasket over the tank nut

ensuring there are not gaps between the

gasket and the chinaware.

Press firmly.