Installation Guide

Tighten handles alternately
until tank contacts bowl.
HAND TIGHTEN ONLY!
Thread, then
hand tighten
water supply.
7301555-100 Rev. 3 3/20
- 3 -
7
9
8
10a 10b
!
WARNING: Overtightening of water supply
line nuts could result in breakage and
potential flooding. If the connection leaks
after hand tightening, replace the supply
line. Do not use any type of sealant on the
water supply connection. Use of plumber’s
putty, pipe dope, or any other type of
sealant will void the warranty.
Before continuing, determine the type of water supply connecation you have from
the chart below and use the appropriate assembly parts required to properly
reconnect the water supply. DO NOT use plumber's putty to seal these fittings.
CAUTION: DO NOT USE
CONE WASHER WITH
PLASTIC SUPPLY LINE.
CAUTION: Overtightening of
LOCK NUT or COUPLING NUT
could result in breakage and
potential flooding.
With correct washers in place
(see Step 10a), tighten
COUPLING NUT 1/4 turn
beyond hand tight.
DO NOT OVERTIGHTEN.
Turn On
Water Supply
These parts must be used as
illustrated to insure water-tight
connection. Use of existing
coupling nut may result in
water leakage. Water supply
tube or pipe must extend at
least 1/2" inside threaded
shank of valve (does not
apply to flanged tubing).
METAL / COPPER
FLARED TUBING
LOCK NUT
COUPLING
NUT
WATER
SHUT-OFF
CONE
WASHER
Use existing
coupling nut
and washer.
METAL FLANGED
TUBING
LOCK NUT
EXISTING
COUPLING
NUT
WATER
SHUT-OFF
EXISTING
WASHER
Captive cone
washers already
included. No
additional washers
needed.
VINYL / BRAIDED
CONNECTOR
COUPLING
NUT
WATER
SHUT-OFF
LOCK NUT
Use existing spiral
cone washer.
Fluidmaster cone
washer may not seal
completely on spiral
type supply line.
METAL SPIRAL
TUBING
LOCK NUT
COUPLING
NUT
WATER
SHUT-OFF
EXISTING
CONE WASHER