Installation Guide

4
755116-100
3
If you plan to install a shower door, a 1 x 4 must be installed in the side pockets on the back of both side walls and a 1 x 3 must be
installed in the top pockets.
A) Cut one end of the 1 x 4 to 45° as shown. (Fig.1) Then cut the 1 x 4 to a length of 70-1/2". Cut the 1 x 3 to a length of 21" for the
3838CW and 25" for the 4242CW.
B) Apply a bead of tub surround adhesive in the pockets of each side wall. Attach the 1 x 3 so that it butts up against the top of the top
pocket. With 45° cut end down and angle facing out, attach 1 x 4 board butting up against the bottom of the 1 x 3. Allow time to cure.
A) Apply a bead of tub surround adhesive down each stud
that will come in contact with the corner panel being sure
to stay below the line you marked. You do not need to
apply adhesive to the corner studs.
B) Lay a bead of sealant along shower base tile flange.
C) Reposition corner panel aligned with pencil line and press
firmly against studs.
4
Stud
Drill clearance
hole for screw
in top nailing
flange
Drill clearance
hole for screw
in side nailing
flange
Mating surface
(square and plum)
Fig. 2 Fig. 3
A) • Locate and drill a clearance hole in the center of the top nailing flange and centered on each stud (see arrows as shown).
• Also drill six evenly spaced clearance holes on the front nailing flange on each side (see arrows as shown).
B) Ensuring mating surface is square and plum (Fig. 2), install galvanized screws through each clearance hole
and into the studs, securing the wall panel.
C) Add a bead of sealant down the vertical edges of corner panel (Fig. 3).
Pencil line
Sealant
Tub Surround
Adhesive
bead
Drill clearance
holes for screws.