Installation Guide

HIGH ARC SINGLE CONTROL

KITCHEN FAUCET WITH SPRAY

4285.051

4285.051F15

Thank you for selecting American-Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--

please read these instructions carefully before you begin.

Installation

Instructions

Certiﬁed t o comply with ANSI A112.18.1M

Plumbers' Putty or CaulkingAdjustable WrenchPhillips Screwdriver

RECOMMENDED TOOLS

Regular Screwdriver

Turn off water at

main supply.

CAUTION

PORTSMOUTH™

M965473 Rev. 1.2

SINK OR

MOUNTING

SURFACE

RING BASE

PUTTY

SPOUT BASE

INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON

Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside

of sink or mounting surface. Hand tighten LOCKNUT (6).

Use a screwdriver to tighten SCREWS (7) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening

the screws slightly each time until all are snug to ensure even pressure.

Make certain the SEAL (9) is properly seated in recess of spout base.

(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1).

Insert all HOSES (2) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and mounting surface.

Follow mounting instructions below to secure faucet to mounting surface.

(B) Installation less ESCUTCHEON (1). Insert all HOSES (2) and SHANK (3) through MOUNTING RING (10) and

mounting surface. Do not use putty.

PAGE 1
Installation Instructions PORTSMOUTH™ 4285.051 4285.051F15 HIGH ARC SINGLE CONTROL KITCHEN FAUCET WITH SPRAY Thank you for selecting American-Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified t o comply with ANSI A112.18.1M M 9 6 5 4 7 3 R ev. 1.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot (Marked with a Red Line) and right supply to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. 2 1 Faucet supplies are 21" long from faucet base.
PAGE 3
5 SERVICE If faucet drips, operate HANDLE several times from "off" to "on." Do not apply excessive force. Clogged CARTRIDGE outlets or inlets may cause reduced flow. To clean, first turn off water supply then: Remove INDEX BUTTON (1), loosen HANDLE SCREW (2) and remove HANDLE (3). Unthread the ESCUTCHEON CAP (4). Unthread three MOUNTING SCREWS (5). Lift CARTRIDGE (6) off MANIFOLD (7). Clean MANIFOLD (7) and CARTRIDGE (6) ports.
PAGE 4
PORTSMOUTH™ HIGH ARC SINGLE CONTROL KITCHEN FAUCET WITH SPRAY MODEL NUMBER 4285.051 4285.051F15 M910288-0070A (2.2 GPM) M910286-0070A (1.