Installation Instructions

Installation

Instructions

M968577 Rev.1.1

Certiﬁed to comply with ANSI A112.18.1M

4332.350.XXX

PEKOE

CAUTION

INSTALL FITTING

Turn off hot and cold water

supplies before beginning.

Plumbers' Putty or Caulking

Adjustable Wrench

Phillips Screwdriver

Channel Locks

Recommended Tools

Make certain the SEAL (1) is properly seated in recess

of faucet body.

Insert supply HOSES (2) and SHANK (3) through center

hole of sink or mounting surface.

Assemble RUBBER WASHER (4), PLASTIC WASHER (5),

METAL WASHER (6) and threaded LOCKNUT (7) onto

SHANK (3) from underside of sink or mounting surface.

Hand tighten LOCKNUT (7) and check that faucet is centered.

Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).

Work your way around LOCKNUT (7), tightening the screws

slightly each time until all are snug to ensure even pressure.

Tubing Cutter

RECESS

Thank you for selecting American-Standard...the benchmark

of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

Single Lever Semi-Professional

Kitchen Faucet

PAGE 1
Installation Instructions PEKOE Single Lever Semi-Professional Kitchen Faucet 4332.350.XXX Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M M968577 Rev.1.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS BLUE STRIPE RED STRIPE Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. 2 Faucet supplies are 27-1/2" long from faucet base.
PAGE 3
4 SERVICE Clogged CARTRIDGE outlets or inlets may cause reduced flow. To clean, first turn off water supply then: Loosen and remove LEVER HANDLE (1). Loosen HANDLE SCREW (2) with 2.5mm Hex Wrench and then pull HANDLE BASE (3) off. Unscrew ESCUTCHEON CAP (4). Unscrew the CARTRIDGE NUT (5). Remove CARTRIDGE (6). Clean inlets of CARTRIDGE (6) and MANIFOLD (7). Reassemble CARTRIDGE (6). Replace CARTRIDGE NUT (5), CAP (4) and HANDLE assembly, check flow.
PAGE 4
PEKOE Single Lever Semi-Professional Kitchen Faucet MODEL NUMBER 4332.350.