Installation & Assembly

6
7
8
18"
4
1
2
3
5
!
U
N
S
C
R
E
W
BE
F
O
R
E
I
N
S
T
A
L
L
I
N
G
2
MAKE WATER SUPPLY CONNECTIONS
4
TEST INSTALLED FAUCET
SPRAY OPERATION
3
CONNECT SPRAY HOSE & INSTALL WEIGHTS
Move HANDLE (1) into "off"
position.
With HANDLE (1) in "off" position,
unthread SPRAY (3) from HOSE (2).
Turn on water supplies.
Operate handle back to front, in COLD
and HOT positions, to flush water lines
thoroughly.
Replace SPRAY (3) onto HOSE (2).
With FAUCET on pull down
SPRAY (4). Check for leaks.
Make sure SPRAY (4) fully
retracks and is seated in
the SPOUT HOLDER (5).
Remove the FAUCET PROTECTION DEVICE (1) from the
HOSE CONNECTOR (2).
Push the SPRAY HOSE END (3) into the HOSE CONNECTOR (2)
until it snaps into place.
With HAND SPRAY (4) seated in SPOUT (5), install WEIGHT (7)
onto HOSE (6) 18 inches from the underside of the sink deck
and secure with SCREW (8).
Check connections for leaks.
(See Section 5)
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly
to wall supplies. Connection on fitting
supplies are 3/8" compression. Connect
left supply (Marked with a Red Stripe) to Hot
and right supply (Marked with Blue Stripe) to
Cold wall supply. Use adjustable wrench to
tighten connections. Do not over tighten.
Faucet supplies are 21" long from faucet base.
Note: If additional supply length is
required, installer must purchase
additional parts separately.
Important: If SUPPLY HOSES (1, 2) are
too long, loop as illustrated to avoid kinking.
1
3
5
1
2
COLD
HOT
REMOVE
M 9 6 5 2 4 3 R E V. 1. 4
2
4