Installation Guide

ManualsBrandsAmerican Standard ManualsBathTownsend 48 in. x 36 in. Single Threshold Shower Base in White

The opening dimensions should be at least 1/8" larger than dimensions shown.

For the best fit, the opening measurements should be verified against the actual shower base received.

SOLID SURFACE SHOWER BASES

MODELS: 6030SMRHOL, 6030SMLHOL, 6032SMRHOL,

6032SMLHOL, 6036SMRHOL, 6036SMLHOL, 4836SMCOL

755438-100 Rev. B 4/18

NOTE: Read instructions completely before proceeding with installation.

SAVE FOR FUTURE USE

Local building codes vary by location. Observe all local plumbing and building codes.

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed

properly, please read these instructions carefully before you begin. (Certain installations may require professional help.)

INSTALLATION INSTRUCTIONS

All product names listed herein are trademarks of AS America, Inc. unless otherwise noted.

6030SMRHOL6030SMLHOL

FRONT

TOP VIEW

LEFT HAND

OUTLET

60"

(1524mm)

4-9/16"

(116mm)

RIGHT SIDE

(51mm)

(25mm)

2" (51mm)

THRESHOLD DEPTH

30"

(762mm)

14-3/4"

(375mm)

30"

(762mm)

4-9/16"

(116mm)

60"

(1524mm)

RIGHT SIDE

(51mm)

(25mm)

2" (51mm)

THRESHOLD DEPTH

TOP VIEW

RIGHT HAND

OUTLET

FRONT

14-3/4"

(375mm)

6032SMRHOL

6032SMLHOL

FRONT

TOP VIEW

60"

(1524mm)

4-9/16"

(116mm)

RIGHT SIDE

(51mm)

(25mm)

2" (51mm)

THRESHOLD DEPTH

32"

(813mm)

15-3/4"

(400mm)

LEFT HAND

OUTLET

32"

(813mm)

4-9/16"

(116mm)

60"

(1524mm)

RIGHT SIDE

(51mm)

(25mm)

2" (51mm)

THRESHOLD DEPTH

TOP VIEW

FRONT

15-3/4"

(400mm)

RIGHT HAND

OUTLET

TOOLS:

TOOLS & MATERIALS REQUIRED....

• Level

• Pencil

• Square

• Tape Measure

• Pipe Wrench

• Slip Joint Pliers

• Screw Driver

• Standard Woodworking Tools

• Personal Safety Equipment

• Caulking Gun

MATERIALS:

• Silicone Sealant

• Drop Cloth

• Mortar Mix or Grout

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS SOLID SURFACE SHOWER BASES MODELS: 6030SMRHOL, 6030SMLHOL, 6032SMRHOL, 6032SMLHOL, 6036SMRHOL, 6036SMLHOL, 4836SMCOL Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Local building codes vary by location. Observe all local plumbing and building codes. TOOLS & MATERIALS REQUIRED..
PAGE 2
LEFT HAND OUTLET 4-9/16" (116mm) 6036SMLHOL 6036SMRHOL 60" (1524mm) 60" (1524mm) RIGHT HAND OUTLET 4-9/16" (116mm) 17-3/4" (451mm) 17-3/4" (451mm) 36" (914mm) 36" (914mm) FRONT FRONT TOP VIEW TOP VIEW 1" (25mm) 2" (51mm) 1" (25mm) 2" (51mm) THRESHOLD DEPTH 2" (51mm) THRESHOLD DEPTH 2" (51mm) RIGHT SIDE RIGHT SIDE 4836SMCOL 48" (1219mm) 24" (610mm) CENTER OUTLET 17-3/4" (451mm) 36" (914mm) FRONT TOP VIEW 1" (25mm) 2" (51mm) 1 2" (51mm) THRESHOLD DEPTH RIGHT SIDE Ensure that the
PAGE 3
2 Shower bases require purchasing a round shower strainer type drain for use with a standard 2" (51mm) plastic schedule 40 waste pipe. Figure B shows the typical drain assembly. Before installing drain into the shower base, remove strainer Figure B. This will be installed after shower base is in its ﬁnal position. Cut the wastepipe height so that the drain body will fit snug in the shower base.
PAGE 4
POST INSTALLATION CLEAN-UP Remove all construction debris. Tile grout can be removed with a wooden popsicle stick or tongue depressor. Do not use wire brushes or any other metal implement on surface. Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or stains may be removed using granular Spic and Span® mixed with water. Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.