Installation Guide

ManualsBrandsAmerican Standard ManualsKitchenAvery Single-Handle Pull-Down Sprayer Kitchen Faucet in Stainless Steel

- 1 -

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly-please read

these instructions carefully before you begin.

RECOMMENDED TOOLS

M965801 Rev.1.1 (7/17)

INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON

AVERY

™

PULL-DOWN

KITCHEN & BAR FAUCET

INSTALLATION

INSTRUCTIONS

4901.300

4901.410

Flat Blade Screwdriver Adjustable Wrench Plumbers’ Putty or CaulkingPhillips Screwdriver

Certied to comply with ANSI A112.18.1M

B (OPTIONAL)

SPOUT BASE

SINK OR

MOUNTING

SURFACE

SPOUT BASE

CAUTION

Turn off water at

main supply

(A) Installation less DECK ESCUTCHEON

• Make certain the SEAL (10) is properly seated in bottom recess of the SPOUT (2). Insert supply HOSES (3), SPRAY HOSE (4)

and SHANK (5) through mounting hole and seat SPOUT BASE onto sink or mounting surface. Do not use putty.

• Insert HOSES (3) through RUBBER WASHER (6), BRASS WASHER (7), and threaded LOCKNUT (8).

• Assemble RUBBER WASHER (6), BRASS WASHER (7), and threaded LOCKNUT (8) onto SHANK (5) from underside

of sink or mounting surface. Hand tighten LOCKNUT (8).

• Use a screwdriver to tighten SCREWS (9) on LOCKNUT (8). Work your way around LOCKNUT (8), tightening the screws

slightly each time until all are snug to ensure even pressure.

(B) Installation with DECK ESCUTCHEON (optional)

• Make certain the SEAL (10) is properly seated in top recess of DECK ESCUTCHEON (1) and SEAL (12) is properly seated

in bottom recess of DECK ESCUTCHEON (1). Do not use putty.

• Screw in two THREAD RODS (13) onto bottom of DECK ESCUTCHEON (1).

• Insert SUPPLY HOSES (3), SPRAY HOSE (4) and SHANK (5) through hole of DECK

ESCUTCHEON (1), and mounting surface.

• Follow mounting instructions above

to secure faucet to mounting surface.

Thread the MOUNTING NUTS (11) to

secure DECK ESCUTCHEON.

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS AVERY™ 4901.300 4901.410 PULL-DOWN KITCHEN & BAR FAUCET Thank you for selecting American Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS • Turn off hot and cold water supplies before beginning. • Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply hose (Red Stripe) to Hot wall supply. Connect right supply hose (Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. 2 1 * Faucet supplies are 35" long from faucet base.
PAGE 3
4 TEST INSTALLED FAUCET & CHECK CONNECTION FOR LEAKS • Move HANDLE (1) into “off” position. • Turn on water supplies and check connections for leaks. • With HANDLE (1) in “off” position, unthread SPRAY (3) from HOSE (2). • Operate HANDLE (2) up and down, left and right to flush water lines thoroughly. • Replace SPRAY (3) onto HOSE (2). 2 • Operate HAND SPRAY and check connections for leaks.
PAGE 4
6 SERVICE If Faucet Drips, Proceed As Follows: • Turn VALVE to OFF position. • Operate HANDLE several times from OFF to ON position. Do not apply excessive force. Clogged CARTRIDGE outlets or inlets may cause reduced flow. To clean, first turn off water supply then: • Remove INDEX BUTTON (1), loosen HANDLE SCREW (2) and remove HANDLE (3). • Unthread ESCUTCHEON CAP (4). Unthread three MOUNTING SCREWS (5). • Lift CARTRIDGE (6) off MANIFOLD (7) and remove CARTRIDGE SEALS (8).
PAGE 5
AVERY™ PULL-DOWN KITCHEN & BAR FAUCET MODEL NUMBER M970267-YYY0A Spray Assembly 4901.410 4901.300 4901.410 M922909-0070A Aerator M964766-0020A Spray With Hose M951483-0070A Cartridge M950413-YYY150A M918511-0070A Spray Assembly 4901.300 Cartridge Screws M907315-YYY0A Escutcheon Cap 2064101P-XXX Escutcheon & Putty Plate FOR 4901.410 M970376-YYY0A Button & Screw Kit M911793-0070A Seal M970266-YYY0A Handle Kit 1660152-XXX Escutcheon & Putty Plate FOR 4901.