Instructions / Assembly

ManualsBrandsAmerican Standard ManualsBathTransitional Slow-Close EverClean Elongated Closed Front Toilet Seat in Linen

TOP MOUNT

760237-100 Rev. A 6/17

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard – the

benchmark of fine quality for over 100 years. To

ensure this product is installed properly, please read

these instructions carefully before you begin. (Certain

installations may require professional help.) Also be

sure your installation conforms to local codes.

NOTE: Pictures may not exactly depict toilet seat

and components.

INSTALLATION INSTRUCTIONS

TOILET SEAT -

TOP MOUNT & BOTTOM MOUNT

Insert plugs into seat

holes in bowl.

Snap hinges with washer

pad into holes on the

bottom of the seat.

For ease of installation of black rubber plugs, insert steel bolt

(capture a few threads), and wet the lower area with some water

(soapy water works best).

NOTE: FLANGE MUST REMAIN ABOVE THE SURFACE.

DO NOT ALLOW PLUG TO FALL THROUGH!

Plug

Bolt

Flange

Bulb

Wet this area with water

S A V E FOR FU TURE US E

IF YOU

HAVE...

TOILET

TOP MOUNT

1A - 10A

BOTTOM MOUNT

1B - 9B

Hinge Cover

Screws

Hinge

Hinge Washer Pad

Rubber Screw

Hinge

Washer

Pad

Install Hinge Washer

Pad into Hinge.

Place seat with hinges onto bowl.

Align seat with front of bowl.

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS TOILET SEAT - TOP MOUNT & BOTTOM MOUNT IF YOU Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes. HAVE... NOTE: Pictures may not exactly depict toilet seat and components.
PAGE 2
7A 8A Push ONLY until bulb goes through. Push down together Open the seat and cover. Push both inside buttons to release seat and cover. Pull the seat and cover upwards to take it off the hinges. Put screws into seat hinge and tighten using a screwdriver. 9A 10A Place seat back on bowl and click seat onto hinges. Place Hinge Cover over the Hinges. BOTTOM MOUNT 2B 1B Hinge Cover Screws Hinge Hinge Washer Pad Hinge Hinge Washer Pad TOILET Install Hinge Washer Pad into Hinge.
PAGE 3
B With the bolts installed, thread the winged nuts, rubber washers and rubber plugs on to the bolts. Finger tighten only so that hinge can still turn. 5B 4B Snap hinges with washer into holes on the bottom of the seat. 6B Place seat with hinges onto bowl. Align seat with front of bowl. 7B Open the seat and cover. Push both inside buttons to release seat and cover. Pull the seat and cover upwards to take it off the hinges. While holding the nut, use a screwdriver to tighten the hinge.
PAGE 4
8B 9B Place seat back on bowl and click seat onto hinges. Place Hinge Cover over the Hinges. Care and Cleaning When cleaning your toilet seat wash it with a mild, soapy water: rinse the seat thoroughly with clear water and dry with a soft cloth. Avoid detergents, disinfectants, or cleaning products in aerosol cans. Never use abrasive scouring powders on your seat. Some bathroom chemicals and cosmetics may damage the seat’s finish.