Installation Guide

Side view of the toilet seat installation parts.
Hinge
Cap
Rubber
Plug
Stainless
Steel Bolt
Adjustment
Washer
Hinge Base
Bolt
Flange
Bulb
PLUG
Hinge
Gasket
Hinge
Base
Adjustment
Washer
1
3
5
8
6
7
4
2
Under Hinge
Base
Hinge
Gasket
Slot
Alignment
Tab
Attach Hinge Gaskets to bottom of Hinge Base.
Make sure Alignment Tabs on Hinge Gaskets
match the slots under the Hinge Base.
Align hinges over holes on toilet bowl.
Insert the plastic adjustment washers
with flat surface facing up.
When the seat is properly aligned with the front edge of the bowl,
slip the bolt through the washer and the bowl bolt holes.
Once properly positioned, tighten
the bolts with your wrench.
The hinge cap covers are designed to
snap lock on to the hinge. Position the
hinge covers and push down on the cover.
7302106-100 Rev. D 7/15
Page 2
For ease of installation of black
rubber plugs, insert steel bolt
(capture a few threads) and wet
the lower area with some water
(soapy water works best).
NOTE: FLANGE MUST REMAIN
ABOVE THE SURFACE.
DO NOT ALLOW PLUG TO FALL
THROUGH!
Wet this area
with water
Once plug is in place,
unscrew and remove bolts
and keep nearby for step 6.
Unscrew and
remove bolts
Push ONLY until
bulb goes through
Push down
together
INSTALLATION #2 - TOP MOUNT WITH RUBBER PLUG