Installation Guide

ManualsBrandsAmerican Standard ManualsPlumbingCadet Elongated Closed-Front Toilet Seat with Soft Close

Hinge

Plastic Wing Nut

Hinge Cover

Plastic

Bolt

760226-100 Rev. 2 7/19

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read

these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.

INSTALLATION INSTRUCTIONS

NOTE: Pictures may not exactly depict toilet seat and components.

Toilet Seat / Top and Bottom Mount

5503A Elongated

5503B Round Front

SAVE FOR FUTURE USE

1 2

INSTALLATION #1: BOTTOM MOUNT WITH PLASTIC WINGNUT

PLUG

For ease of installation of black rubber plugs, insert

steel bolt (capture a few threads) and wet the lower

area with some water (soapy water works best).

Once plug is in place, unscrew and remove

bolts and keep nearby for step 4.

NOTE: FLANGE MUST REMAIN ABOVE THE SURFACE.

DO NOT ALLOW PLUG TO FALL THROUGH!

Bolt

Flange

Bulb

Washer

Wet this area

with water

Side view of the toilet

seat installation parts.

Side view of the toilet seat installation parts.

Position the seat and align hinges

over holes on toilet bowl.

Tighten the bolts using your screwdriver.

The hinge cap covers are designed to snap

lock on to the hinge. Position the hinge covers

and push down on the cover.

When the seat is properly aligned with

the front edge of the bowl slip the bolt

through the bowl bolt holes.

With the plastic bolts installed, thread the

winged plastic nuts on to the bolts.

2 3

INSTALLATION #2: TOP MOUNT WITH RUBBER PLUG

Push ONLY until

bulb goes through

Push down

together

Hinge Cover

Rubber Plug

Hinge

Stainless Steel Bolt

Unscrew and

remove bolts

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Toilet Seat / Top and Bottom Mount 5503A Elongated 5503B Round Front Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes. NOTE: Pictures may not exactly depict toilet seat and components.
PAGE 2
5 4 When the seat is properly aligned with the front edge of the bowl, slip the bolt through the washer and the bowl bolt holes. 6 Tighten the bolts using your screwdriver. The hinge cap covers are designed to snap lock on to the hinge. Position the hinge covers and push down on the cover. Care and Cleaning When cleaning your toilet seat wash it with a mild, soapy water: rinse the seat thoroughly with clear water and dry with a soft cloth.