Installation Guide

Fig. 2
1524mm
(60)
14"
(356mm)
3-3/4"
(96mm)
2-3/4"
(71mm)
3"
(76mm)
21"
(mm)
2
4
3
1
1
1
20"
(500mm)
MOUNTING HOLES
SUPPLIES
WASTE
ENCLOSURE
MOUNTING
HOLES
LAVATORY RIM OR
MOUNTING SURFACE
3
NOTE: If using Mixing Valve (optional) See Sheet
#M968808 for installation instructions.
Fig. 3
1
2
1
3
3
Fig. 4
2
COLD WATER OR
TEMPERED
WALL SUPPLY
Fig. 4a
4
M965650 Rev. 2.3 (9/20)
1. Determine location of CONTROL BOX (1). It must be
located with-in the 14" (356mm) by 21" (533mm)
shaded area shown in Figure 2 in order for electrical
connections from the spout assembly to be made.
NOTE: CONTROL BOX SUPPLY HOSE is 20". Distance
between wall supply and CONTROL BOX (1) must be
taken into consideration.
2. Remove tape from CONTROL BOX COVER (2) and
pull off COVER (2). Hold the CONTROL BOX (1)
in desired location and mark the four mounting hole
locations as shown.
NOTE: Find plastic bag containing 4 M5X16 screws
to be used for securing the CONTROL BOX COVER (1)
when installation is complete.
NOTE: For AC installation, make power supply
connection before mounting CONTROL BOX (1) to wall.
3. It is recommended that the CONTROL BOX (1) be
secured
to a wall stud or cross brace within the wall using the
SCREWS (3) supplied. If the CONTROL BOX (1) is to be
installed on tile or plaster walls, the ANCHORS (4) and
SCREWS (3) should be used.
MOUNT CONTROL BOX; Fig. 2
2
1. Connect SUPPLY NUT (1) from spout hose to nipple on
top of CONTROL BOX (2). Tighten with adjustable
wrench to make a water tight connection. Fig. 3.
NOTE; If using the optional Mixing Valve See Sheet
#M968808 for installation instructions.
CONNECT SPOUT HOSE TO
CONTROL BOX; Fig. 3
CONNECT WATER SUPPLY TO
CONTROL BOX AND WALL SUPPLY;
Fig. 4, 4a
3
4
1. Insert FIBER WASHER (4) into SUPPLY NUT (1) on
CONTROL BOX (2).
2. Connect FLEXIBLE SUPPLY HOSE (3) to SUPPLY
NUT (1) on CONTROL BOX (2). Tighten to make a
water tight connection. Use two wrenches to tighten
if necessary. Fig. 4.
3. Connect FLEXIBLE SUPPLY HOSE (3) directly to wall
supply. Connection on FLEXIBLE SUPPLY HOSE (3)
is 3/8" compression. Use adjustable wrench to
tighten connection. Do not over tighten. Fig. 4a.
Note: FLEXIBLE SUPPLY HOSE (3) measures 20" from the
bottom of the CONTROL BOX (2) base. If additional supply
length is required, installer must purchase parts separately.
Important: If FLEXIBLE SUPPLY HOSE (3) is too long,
loop to avoid kinking.