Installation Sheet

TOOLS REQUIRED; Fig. 2
Fig. 2
1 Slip Joint Pliers
2 Adjustable Wrench
3 Plumbers' Putty or Caulking
4 Phillips Screwdriver
5 Flat Blade Screwdriver
6 Electric Drill & 1/4" Drill Bit
7 Tape Measure
1
2
3
4
5
6
7
INSTALL SPOUT ASSEMBLY;
Fig. 1
INSTALLATION
2
10'
1
Fig. 1
Roughing-in Dimensions
114mm
(4-1/2)
500mm
(20")
1524mm
(60)
381mm
(15)
3/8" COMP.
131mm
(5-1/8)
32mm (1-1/4)
125mm
(4-7/8)
81mm
(3-3/16)
49mm
(2)
141mm
(5-1/2)
11-1/8 "
(284mm)
6-1/8"
(155mm)
MOUNTING
SURFACE
381mm
(15)
49mm
(2)
7"
(179mm)
1. (Optional) Assemble DECK PLATE (1) and PUTTY
PLATE (2) to FAUCET BODY (3) with SCREW (4).
2. Insert CABLES (5) , FLEX HOSE (6) and SPOUT
SHANK (7) through center hole of mounting surface.
3. Assemble "C" WASHER (8) and LOCKNUT (10)
onto threads of SPOUT SHANK (7) from underside
of mounting surface.
4. Align FAUCET (3) and tighten LOCKNUT (10). If
using DECK PLATE (1) hand tighten DECK PLATE
SPIN NUTS (11) to secure FAUCET (3) to mounting
surface. Fig. 1b.
M965650 Rev. 2.0 (3/19)
10
11
5
7
7
6
8
3
1
1
2
2
Fig. 1
4
5
SENSOR
CABLES
CAUTION
Turn off hot and cold water supplies before beginning
GENERAL DESCRIPTION:
Electronic faucet with proximity operation. Vandal resistant
solid brass construction single post mounting. Operates on
DC (battery/power pack) or AC permanent power
(plug-in/hardwire). In-line strainer for solenoid is integral.
Single inlet 3/8 compression, built-in check valves, and
flexible stainless steel 16-1/4" reach inlet hose for spout
connection.
Note: All plumbing and electrical wiring must be
installed in accordance with applicable codes,
regulations and standards.
CAUTION: Use only American Standard
supplied cable sets. Using non-AS supplied
cables, or cutting, splicing or modifying any
components will void the warranty.
RECOMENDED ELECTRICAL BOX OR
EQUIVALENT BY OTHERS
HARD-WIRED AND MULTI AC 10’ MAX. CABLE LENGTH
4" (102mm) SQ. X 3-1/2" (89mm) DEEP ELECTRICAL BOX
Hubbel-RACO #256 OR EQUAL (BY OTHERS).