Installation Guide

5
M965652 Rev. 1.9 (3/19)
A
DC VERSIONS ; Fig. 1
• PWRX
• STANDARD BATTERY
1. Remove CONTROL BOX COVER (1). Fig. 1.
2. Feed the CABLES (2) through the top of CONTROL BOX
(3). Fig. 1a.
FOR STANDARD BATTERY VERSION ONLY
3. Insert BATTERY (4) into BATTERY HOLDER (5),
make sure the shape of the BATTERY (4) follows the
shape of the BATTERY HOLDER (5) and terminal end
is inserted rst. Fig. 1b.
4. Insert the BATTERY CONNECTOR (5a) from the
Standard Battery or PWRX Battery Pack through side
GROMMET (6) as shown. Fig. 1c.
5. Connect SOLENOID CABLE (7) and BATTERY
CONNECTOR (5a) to CABLES (2). Place Standard
Battery or PWRX Battery Pack into housing. Fig. 1d.
6. Reinstall CONTROL BOX COVER (1). Tighten cover
screws rmly.
Fig. 1a
Fig. 1b
Fig. 1
2
3
1
4
5
INSTALL BATTERY
CR-P2
5a
5
Fig. 1c
7
2
STANDARD
BATTERY
PWRX
5a
5a
6
STANDARD
BATTERY
PWRX
Fig. 1d
5a
CAUTION: Use only American Standard supplied cable sets.
Using non-AS supplied cables, or cutting, splicing or modifying
any components will void the warranty.
ELECTRICAL INSTALLATION
Product Page
Plug-In AC Power Kit (PK00.PAC)
6
Hard-Wired AC Power Kit (PK00.HAC)
6
Multi-AC Power Kit (PK00.MAC)
7