Installation Guide

M 9 6 5 14 3 R E V. 1. 2

SINGLE CONTROL KITCHEN FAUCET

WITH REMOTE VALVE

INSTALLATION

INSTRUCTIONS

Certiﬁed to comply with ANSI A112.18.1M

INSTALL FAUCET

GROOVE IN BASE

OF FAUCET

Thank you for selecting American-Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--

please read these instructions carefully before you begin.

RECOMMENDED

TOOLS

Adjustable Wrench Regular Screwdriver Phillips Screwdriver

Turn off water at

main supply.

CAUTION

6114.300

6114.301

6114.380

6114.381

Assemble RUBBER WASHER (4), BRASS WASHER (5) and threaded LOCKNUT (6) onto SHANK (3) from underside

of sink or mounting surface. Hand tighten LOCKNUT (6). Check that rotation of HANDLE (7) from HOT to COLD

is centered.

Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening the

SCREWS (8) slightly each time until all are snug to ensure even pressure.

Insert SEAL WASHER (1) into groove in base of faucet. Insert supply HOSES (2) and SHANK (3) through sink or

mounting surface. Figure 1.

Assemble RUBBER WASHER (15), BRASS WASHER (16), and threaded LOCKNUT (17) onto SHANK (14) from

underside of sink or mounting surface. Align SPOUT (18, 18a) and tighten LOCKNUT (17).

Install SPOUT ASSEMBLY: Insert SEAL WASHER (13) into groove in base of spout. Insert SPOUT SHANK (14) through

sink or mounting surface. Figure 2.

Install SPRAY HOLDER: (6114.301/.381) Insert SPRAY HOLDER (9) into ESCUTCHEON (10). Insert SEAL (11) into

underside of ESCUTCHEON (10). From underside of sink or mounting surface thread LOCKNUT (12) onto shank of

SPRAY HOLDER (9) and tighten.

Figure 1

Figure 2

18 18a

Channel Locks

GROOVE IN BASE

OF SPOUT

Monterrey Kitchen Faucets

PAGE 1
Monterrey Kitchen Faucets SINGLE CONTROL KITCHEN FAUCET WITH REMOTE VALVE INSTALLATION INSTRUCTIONS 6114.300 6114.301 6114.380 6114.381 Thank you for selecting American-Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M M 9 6 5 14 3 R E V. 1.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS Connect FLEXIBLE SUPPLIES (1) (1/2" X 3/8") to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply to the Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. Note: If additional supply length is required, installer must purchase those parts separately. Important: If SUPPLY HOSES (1) are too long, loop as illustrated to avoid kinking.
PAGE 3
5 TEST INSTALLED FAUCET Move HANDLE (1) down into "off" position. 2 Remove AERATOR (2). Operate HANDLE (1) up and down, in COLD and HOT positions, to flush water lines thoroughly. Replace AERATOR (2). 1 With HANDLE (1) down in "off" position, pull HAND SPRAY (3) from holder and direct SPRAY END (3) into sink. With faucet on push BUTTON (4) to activate HAND SPRAY (3). Release BUTTON (4) to stop spray and return HAND SPRAY (3) to holder.