Installation Guide

- 3 -

M965804 (4/17)

• Thread CABLE CONNECTOR (1) clockwise

onto DRAIN BODY CONNECTION (2) and

hand tighten. Fig. A.

Your new POP-UP DRAIN installation is

now complete. Fig. B.

Note: Tailpeice on pop-up drain is 1-1/4” O.D.

Fig. B.

CHECK OPERATION OF POP-UP

ATTACH CABLE CONNECTOR

Fig. A.

Fig. B.

1-1/4” O.D.

• Operate LIFT KNOB (1) to verify that STOPPER (2) opens

and closes.

Note: If STOPPER (2) does not open and close

properly then refer to the “troubleshooting section” of

these instructions.

MAKE WATER SUPPLY AND WASTE CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE

PURCHASED SEPARATELY.

• Connect water supply to FAUCET (1) with 1/2" IPS

FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).

Use adjustable wrench to tighten connections. Do not over

tighten.

• B e careful not to kink copper supply when bending.

Use tubing cutter to cut to proper length.

• Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to

waste outlet.

COMPRESSION

NUT

3/8” COMPRESSION

CONNECTION

COUPLING

NUT

FLEXIBLE

SUPPLIES

3/8 O.D.

BULL-NOSE

RISERS

1/2" PIPE

THREAD

FERRULE

HOT

COLD