Installation Guide
- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please
read these instructions carefully before you begin.
RECOMMENDED TOOLS
1
M965808 (3/17)
INSTALLATION OF MOUNTING BRACKETS FOR ALL WALL MOUNTED ACCESSORIES
EDGEMERE
™
18" TOWEL BAR
24" TOWEL BAR
TOWEL RING
ROBE HOOK
TOILET PAPER HOLDER
WITH PIVOTING BAR
INSTALLATION
INSTRUCTIONS
7018.018 Series
7018.024 Series
7018.190 Series
7018.210 Series
7018.230 Series
Certied to comply with ANSI A112.18.1M
2
1
1
3
3
3/8" (9 mm)
3/4" (19 mm)
2
LEVEL
C
L
DRILL PILOT HOLE FOR
WOOD SCREW (2) OR
1/4" DIA. HOLE FOR
ANCHOR (3)
Phillips Screwdriver
10'
Tape Measure
Electric Drill
Level
Flat Head Screwdriver
• The WALL MOUNTED ACCESSORIES work best if secured to a wall stud or cross brace within the wall, using the SCREWS
(2) supplied.
• If the ACCESSORY is to be installed on a tile or plaster wall, the ANCHORS (3) and SCREWS (2) should be used.
• Determine desired height and location (optional) and mark a center line. Make sure the centerline is level. Using the
MOUNTING BRACKET (1) as a template, mark the two spots for the mounting holes. If MOUNTING BRACKET (1) is secured
to a stud or cross brace. drill small pilot holes for SCREWS (2).
• For installations on tiled walls or drywall, use TILE ANCHORS (3) and SCREWS (2) for securing MOUNTING BRACKET (1) to
wall. Drill two 1/4" diameter holes a minimum of 1-1/4" deep. Insert the two TILE ANCHORS (3) ush with face of nished wall.
Place MOUNTING BRACKET (1) over TILE ANCHORS (3) and insert SCREWS (2) provided with a at blade screwdriver.
See illustration below.
• Secure MOUNTING BRACKET (1)
to wall with SCREWS (2).