Installation Guide

ManualsBrandsAmerican Standard ManualsBathDelancey Single Hole Single-Handle Bathroom Faucet with Side Handle in Polished Nickel

- 1 -

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ne quality for over 140 years.

To ensure that your installation proceeds smoothly-please read

these instructions carefully before you begin.

RECOMMENDED TOOLS

M965991 (10/18)

INSTALL LAVATORY FAUCET

Delancey

Single Control Lavatory Faucet

INSTALLATION

INSTRUCTIONS

7052121

7052124

Certied to comply with ANSI A112.18.1M

CAUTION

Turn off hot and cold water

supplies before begining.

Adjustable Wrench

Channel Locks

Regular Screwdriver

Phillips Screwdriver

Plumbers' Putty or Caulking

GROOVE IN

(FAUCET BASE)

MOUNTING

SURFACE

• Seat SEAL (1) into groove in under side of ESCUTCHEON BASE (2).

• Seat ESCUTCHEON BASE (2) with collar facing up into groove

in faucet base.

• Feed FAUCET SUPPLIES (3) and MOUNTING SHANK (4) through

hole in mounting surface.

• From below, install GASKET (5) and MOUNTING NUT (6) onto

SHANK (4). Secure Faucet with MOUNTING NUT (6). Before nal

tightening, adjust Faucet so that it is centered. Tighten MOUNTING

NUT (6) to complete faucet mounting.

HOT LINE FOR HELP

For toll-free information and answers to your questions, call:

1 (800) 442-1902

Mon. - Fri. 8:00 a.m. to 8:00 p.m. EST

Saturday 10:00 a.m. to 4:00 p.m. EST

IN CANADA 1-800-387-0369

(TORONTO 1-905-306-1093)

Weekdays 8:00 a.m. to 7:00 p.m. EST

IN MEXICO 01-800-839-1200

Summary of content (3 pages)

PAGE 1
INSTALLATION INSTRUCTIONS 7052121 7052124 Delancey® Single Control Lavatory Faucet Thank you for selecting American Standard... the benchmark of fine quality for over 140 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS • Turn off hot and cold water supplies before beginning. • Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot and right supply to the Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. • Faucet supplies are 28" long from faucet base. Note: If additional supply length is required, installer must purchase additional parts separately.
PAGE 3
4 TEST INSTALLED FAUCET AND CHECK FOR LEAKS OFF • With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks. ON COLD 3 • Remove AERATOR (3). HOT • Operate HANDLE (1) to flush water lines thoroughly. • Replace AERATOR (3). 1 HOT COLD 2 5 SERVICE CAUTION Turn off hot and cold water supplies before beginning. • To remove or replace cartridge: – Turn valve to OFF position. – Remove HANDLE SCREW (2). – Pull off HANDLE (3) and CAP (4).