Installation Guide

- 2 -
2
M965767 Rev. 1.2 (1/20)
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to wall
supplies. Connection on tting supplies are 3/8"
compression. Connect left supply hose (Red Stripe) to Hot
wall supply. Connect right supply hose (Blue Stripe) to Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
*
Faucet supplies are 21" long from faucet base.
• Note: If additional supply length is required, installer
must purchase additional parts separately.
• Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
MAKE WATER SUPPLY CONNECTIONS
3
CONNECT SPRAY HOSE & INSTALL WEIGHT
4
CHECK CONNECTIONS FOR LEAKS
• Move HANDLE into “off” position.
• Turn on water supplies and check
connections for leaks.
CHECK CONNECTIONS
FOR LEAKS
RED
STRIPE
BLUE
STRIPE
1
2
COLD
HOT
• Thread the SPRAY HOSE END (2) into the HOSE CONNECTOR (1).
• With HAND SPRAY (3) seated in SPOUT (4), install WEIGHT (6)
onto HOSE (5) 21 inches from the underside of the sink deck
and secure with LATCH (7).
• With one weight, spray will retract and dock potentially
requiring slight assistance.
7
6
1
2
3
4
21"
(610 mm)
5