Installation Guide

ManualsBrandsAmerican Standard ManualsBathColony Pro 4 in. Centerset Single-Handle Low-Arc Bathroom Faucet with Pop-Up Drain in Legacy Bronze

- 1 -

SINK OR

MOUNTING

SURFACE

(HAND TIGHTEN)

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly-please read

these instructions carefully before you begin.

RECOMMENDED TOOLS

M965766 (8/16)

INSTALL FAUCET

COLONY

PRO

SINGLE CONTROL

CENTERSET

LAVATORY FAUCET

INSTALLATION

INSTRUCTIONS

7075.054 / 7075.055 / 7075.056

7075.050 / 7075.004 / 7075.005

7075.006 / 7075.002 / 7075.000

Screwdriver Adjustable Wrench Tubing CutterChannel Locks

Certied to comply with ANSI A112.18.1M

CAUTION

Turn off hot and cold water

supplies before begining.

• Insert FAUCET (1) and POP-UP CABLE (2) through mounting

holes of Sink or Mounting Surface.

• Assemble LOCKNUTS (3) onto SHANKS (4) from under

side of Sink. Hand tight

Summary of content (4 pages)

PAGE 1
COLONY® PRO SINGLE CONTROL CENTERSET LAVATORY FAUCET INSTALLATION INSTRUCTIONS 7075.054 / 7075.055 / 7075.056 7075.050 / 7075.004 / 7075.005 7075.006 / 7075.002 / 7075.000 Thank you for selecting American Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.
PAGE 2
INSTALL POP-UP DRAIN 2a • Push TAIL PIECE (11) down into TRAP (C) (threaded end up). 1 • Thread LOCKNUT (5), WASHER (4) and GASKET (3) (Bevel side up) onto DRAIN BODY (10). 2 • Apply a bead of PUTTY (D) to underside of FLANGE (2). A • Feed DRAIN BODY (10) up through SINK (A) and thread the FLANGE (2) fully onto DRAIN BODY (10). D • Tighten LOCKNUT (5) firmly, keeping the pivot rod hole pointed towards the back of the sink. 3 6 4 7 • Assemble PIVOT ROD (9) as shown in Figure-2a.
PAGE 3
5 TEST INSTALLED FITTING ON OFF • With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks. 1 COLD HOT • Remove AERATOR (3). • Operate HANDLE (1) to flush water lines thoroughly. 3 • Replace AERATOR (3). 4 CHECK DRAIN CONNECTIONS • Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in Sink. • Release POP-UP KNOB (4) down and check all drain connections and “P” trap for leaks.
PAGE 4
COLONY® PRO SINGLE CONTROL CENTERSET LAVATORY FAUCET MODEL NUMBERS 7075.054 / 7075.055 / 7075.056 7075.050 / 7075.004 / 7075.005 7075.006 / 7075.002 / 7075.