Installation Instructions

- 1 -

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly-please

read these instructions carefully before you begin.

RECOMMENDED TOOLS

M965765 (8/16)

COLONY

PRO

WIDESPREAD LAVATORY FAUCET

INSTALLATION

INSTRUCTIONS

7075.800

7075.802

Plumbers’ Putty

or Caulking

Adjustable Wrench Channel Locks

Phillips Screwdriver

Certied to comply with ANSI A112.18.1M

• Insert SPOUT SHANK (1) through center hole of

SINK (2), making sure RUBBER RING (3) is properly

positioned.

• Assemble FRICTION WASHER (4) and LOCKNUT (5)

onto threads of SPOUT SHANK (1) from underside

of SINK (2).

• Insert LIFT ROD (6) through SPOUT (7). Align SPOUT

(7) and tighten LOCKNUT (5).

INSTALL SPOUT

CAUTION

Turn off hot and cold water

supplies before beginning.

• Insert VALVE BODY (2), RUBBER RING (3), and two

hoses through the side hole of the sink.

• From under sink tighten LOCK NUT (1) to secure

VALVE BODY (2).

• Connect TEE ASSEMBLY (4) to HOSE (5).

Tighten COUPLING NUT (6).

• Tighten SPOUT BODY SUPPLY HOSES (7) to TEE

ASSEMBLY (4).

VALVE INSTALLATION

PAGE 1
INSTALLATION INSTRUCTIONS 7075.800 7075.802 COLONY® PRO WIDESPREAD LAVATORY FAUCET Thank you for selecting American Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.
PAGE 2
3 INSTALL POP-UP DRAIN • Apply a bead of putty to underside of FLANGE (1). 1 3a 1 • Drop FLANGE (1) into LAVATORY DRAIN (2). From below assemble RUBBER GASKET (3), METAL WASHER (4) and LOCK NUT (5). Do not tighten. 2 3 4 5 3b 4 • Place SEAL (1) with small end facing up into TAILPIECE (2) and tighten against DRAIN BODY (4). PIVOT ROD (3) opening in TAILPIECE (2) should face the rear of the lavatory. Tighten LOCK NUT (5) with channel locks. Do not over tighten.
PAGE 3
4 TEST INSTALLED FAUCET • Remove AERATOR. With handles in OFF position, turn on water supplies and check all connections for leaks. • Operate both handles to flush water lines thoroughly. Operate LIFT ROD and check DRAIN for leaks. Replace AERATOR. AERATOR 5 IF FAUCET DRIPS PROCEED AS FOLLOWS: • Aerator may accumulate dirt causing distorted and reduced water flow. Remove aerator and rinse clean. • If spout drips, operate handles several times from OFF to ON position.
PAGE 4
COLONY® PRO WIDESPREAD LAVATORY FAUCET MODEL NUMBER M970190-YYY0A LEVER HANDLE KIT M950145-YYY0A POP-UP KNOB & ROD 7075.800 7075.