Installation Instructions

- 2 -
3
M965765 (8/16)
• Apply a bead of putty to underside
of FLANGE (1).
INSTALL POP-UP DRAIN
3b
• Place SEAL (1) with small end facing up into TAILPIECE (2) and tighten
against DRAIN BODY (4). PIVOT ROD (3) opening in TAILPIECE (2) should
face the rear of the lavatory. Tighten LOCK NUT (5) with channel locks.
Do not over tighten.
1
3a
1
3
4
2
5
3
2
1
5
4
3c
• Assemble PIVOT ROD (1), PIVOT NUT (2), CLIP (3) and SEAL (4) as
shown. Hand tighten PIVOT NUT (2) Drop STOPPER (5) into drain.
(For vandal proof drain rotate stopper so PIVOT ROD (1) goes through
EYE (6) of STOPPER (5). Make connection to “P” TRAP.
• Remove one end of CLIP (3) from PIVOT ROD (1) by squeezing ends
together while sliding.
• Insert PIVOT ROD (1) into second or third hole in EXTENSION (7) and
reassemble CLIP (3). (EXTENSION (7) may need to be bent.)
• Adjust STOPPER (5) height by repositioning EXTENSION (7) and
tightening THUMBSCREW (8).
6
5
2
4
1
8
7
3
• Drop FLANGE (1) into LAVATORY
DRAIN (2). From below assemble
RUBBER GASKET (3), METAL
WASHER (4) and LOCK NUT (5).
Do not tighten.