Dimensions Guide

- 1 -
SPOUT BASE
3
Fig. A.
Fig. B.
1
2
4
7
8
12 Blue Stripe (COLD)
12 Red Stripe
(HOT)
10
13a
13a
10
13
10a
11
5
6
14
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
RECOMMENDED TOOLS
1
M965956 (6/18)
INSTALL SPOUT
STUDIO
®
S
DUAL CONTROL WIDESPREAD
LAVATORY FAUCET
INSTALLATION
INSTRUCTIONS
7105857
7105877
Flat Head Screwdriver
Adjustable Wrench Tubing CutterSlip Jaw Pliers
Certied to comply with ANSI A112.18.1M
CAUTION
Turn off hot and cold water
supplies before begining.
1A
INSTALL VALVE BODIES
Fig. A.
• Insert SHANK (1) and HOSE (2) through center hole, making sure
SEAL WASHER (3) is properly seated in spout base.
• From below, push GASKET (5) with RETAINING WASHER (6) onto MOUNTING
STUD (4). Secure faucet with MOUNTING NUT (14), pushing faucet to back of
sink, so SUPPLIES (3) rests against mounting hole.
• Align and center SPOUT. Tighten LOCKNUT (5).
Hex Wrench
Fig. B.
• Place SEAL WASHER (7) under HANDLE BASE (8)
and make sure it sits properly inside the groove of
the deck adapter.
• Remove LOCKNUT (9) and RUBBER WASHER
(10), FRICTION WASHER (10a) from SIDE VALVE
SHANKS (11).
• Insert Hot and Cold SIDE VALVE HOSES (12),
FLEXIBLE SUPPLIES (13a) into mounting holes
making sure the SEAL WASHERS (7) are
properly seated in each HANDLE BASE (8).
• Assemble SPACER (13) RUBBER WASHER (10),
FRICTION WASHER (11a) and thread LOCKNUT
(10a) onto each SIDE VALVE SHANK (11) from
underside of sink or mounting surface.
NOTE: SPACER (13) not needed for deck
thickness larger then 3-1/4".
• Align and center SIDE VALVES. Tighten
LOCKNUTS (9).
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.