Installation Guide

2
1
4
9
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES (1) to flush water lines thoroughly.
Replace AERATOR (3).
5
2
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB (4) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
11
“P” TRAP
WASTE
OUTLET
4
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
M965017 REV.1.4
3
SERVICE (7415 & 7420)
To change direction of handle rotation, proceed as follows:
10
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Rotate HANDLE ESCUTCHEON (1) counter-clockwise
and pull off.
Remove ADAPTER SCREW (3) and ADAPTER (2).
Remove SPRING CLIP (4).
Lift STOP WASHER (5), turn 90˚ and replace.
Replace SPRING CLIP (4).
Replace ADAPTER (2) and ADAPTER SCREW (3).
Align HANDLE and push onto ADAPTER (2).
Turn HANDLE ESCUTCHEON (1) clockwise to tighten.
AERATOR (6) may accumulate dirt causing distorted and
reduced water flow. Remove AERATOR (6) and rinse clean.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
1
4
90˚
5
2
3