Installation Guide

• Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to
wall supplies. Connection on fitting supplies are 3/8"
compression. Connect the supply hose with the red
label to the Hot wall supply. Connect the supply hose
with the blue label to the Cold wall supply.
Use an adjustable wrench to tighten connections.
Do not over tighten.
*
Faucet supplies are 38" long from faucet base.
• Note: If additional supply length is required,
installer must purchase additional parts
separately.
• Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
1
2
COLD
HOT
Red
Blue
2
MAKE WATER SUPPLY CONNECTIONS
C
3 4
CONNECT SPRAY HOSE
INSTALL WEIGHT
1
2
3
8
7
6
24"
(610mm)
4
5
• Push the SPRAY HOSE END (2) into the HOSE
CONNECTOR (1) slide down LOCKING COLLAR
(3) until it snaps into place to secure connection.
• With SPRAY HEAD (4) seated in SPOUT (5),
install WEIGHT (7) onto HOSE (6) 24 inches from
the underside of the sink deck and secure with
LATCH (8).
NOTE: there is a label on the hose indicating
weight placement.
Turn off hot and cold water
supplies before beginning.
SPEED CONNECT