Installation Guide

3
DRAIN INSTALLATION
Assembly GASKET (2) WASHER (3) and LOCKNUT (4)
onto DRAIN BODY (1). Tighten LOCKNUT (4) firmly.
Assembly TAILPIECE (5) to DRAIN BODY (1).
Apply a bead of PUTTY to underside of
DRAIN BODY FLANGE (1).
Feed DRAIN BODY (1) down through lavatory.
PUTTY
2
1
3
4
5
2
MAKE WATER SUPPLY CONNECTIONS
LOOP SUPPLIES
IF REQUIRED
28"
1
2
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly
to wall supplies. Connection on fitting
supplies are 3/8" compression. Connect
left supply to Hot and right supply to the Cold wall
supply. Use adjustable wrench to tighten
connections. Do not over tighten.
Faucet supplies are 28" long from faucet base.
Note: If additional supply length is required,
installer must purchase additional parts separately.
Important: If SUPPLY HOSES (1, 2) are
too long, loop as illustrated to avoid kinking.
Figure A.
COLD
COLD
HOT
HOT
Figure A.
M965228 REV. 1.5 (2/15)