Installation Guide

VESSEL LAVATORY FITTING

Installation

Instructions

Certiﬁed to comply with ANSI A112.18.1

7440.151

7440.152

Turn off hot and cold water

supplies before beginning.

CAUTION

Adjustable Wrench

Channel Locks

Flat Head Screwdriver

Phillips ScrewdriverPlumbers' Putty or Caulking

INSTALL LAVATORY FAUCET

Seat SEAL (1) into groove in under side of ESCUTCHEON BASE (2).

Feed FAUCET SUPPLIES (3) and MOUNTING SHANK (4) through

hole in mounting surface.

Slide EXTENSION (8) over FAUCET SUPPLIES (3). Thread

EXTENSION (8) onto FAUCET BODY (9) and fully tighten.

CAUTION: Do not damage ﬁnish on faucet EXTENSION (8) when tightening.

From below, install SUPPORT PLATE (7) GASKET (5) and MOUNTING

NUT (6) onto SHANK (4). Secure Faucet with MOUNTING NUT (6).

Before ﬁnal tightening, adjust Faucet so that it is centered. Tighten

MOUNTING NUT (7) to complete mounting.

NOTE: For thick deck installations, the SUPPORT PLATE (7) can be omitted.

Recommended Tools

Thank you for selecting American-Standard...the benchmark

of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

MOUNTING SURFACE

GROOVE

(FAUCET BASE)

QUENTIN

™

M965228 REV. 1.5 (2/15)

PAGE 1
Installation Instructions QUENTIN™ 7440.151 7440.152 VESSEL LAVATORY FITTING Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1 M965228 REV. 1.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot and right supply to the Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. Faucet supplies are 28" long from faucet base. Note: If additional supply length is required, installer must purchase additional parts separately.
PAGE 3
4 TEST INSTALLED FAUCET AND CHECK FOR LEAKS OFF With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks. ON COLD 3 Remove AERATOR (3). HOT 1 Operate HANDLE (1) to flush water lines thoroughly. Replace AERATOR (3). HOT COLD 2 5 SERVICE CAUTION Turn off hot and cold water supplies before beginning. To remove or replace cartidge: Fig. A. Turn valve to OFF position. Remove HANDLE SCREW (2). Pull off HANDLE (3) and CAP (4).
PAGE 4
QUENTIN™ VESSEL LAVATORY FITTING MODEL NUMBER 7440.151 7440.