Replacement Part List

SERVICE
4
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Remove HANDLE and BONNET NUT.
Remove SPRING CLIP.
Lift STOP WASHER, turn 90° and replace.
Replace SPRING CLIP.
Replace BONNET NUT, HANDLE, SCREW, and INDEX.
AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90°.
Plastic SCREEN in CARTRIDGE may accumulate dirt causing reduced water flow. To clean, first
turn off hot and cold water supplies, then:
Remove HANDLE and BONNET NUT.
Remove CARTRIDGE by pulling up.
Thoroughly rinse plastic SCREEN at base of CARTRIDGE.
Replace CARTRIDGE until flange is tight against valve body.
Turn valves OFF.
Replace BONNET NUT, HANDLE, SCREWand INDEX.
60185 Rev. 1.7 (11/15)
3
CARTRIDGE
SCREEN
SPRING
CLIP
STOP
WASHER
90°
TEST INSTALLED FAUCET
Remove AERATOR.
With handle in OFF position, turn on water supplies and check
all connections for leaks.
Operate both handles to flush water lines thoroughly. Check
spout mounting and hose connections for leaks.
Operate LIFT ROD and check DRAIN for leaks.
Turn handles into OFF position and replace AERATOR.