Use & Care Guide

© 2003 American Standard Inc.
CI-71
AKRON™
SERVICE SINK
ENAMELED CAST IRON
AKRON™ SERVICE SINK
• Enameled cast iron (inside only enameled)
• Supplied with wall hanger and rim guard
• Available with plain back or drilled back
for faucet
❏ 7695.008
Drilled back for faucet
❏ 7695.000
Plain back (no faucet hole drilling)
❏ 8379.026
Rim Guard
Nominal Dimensions: 24” x 20”
(610 x 508mm)
Bowl sizes:
19-7/8” (505mm) wide,
16-3/8” (416mm) front to back,
10-1/2” (267mm) deep
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.1 for Cast Iron Plumbing Fixtures
• CAN / CSA B45 Series
To Be Specified
❏ Faucet: 8340.235 exposed yoke wall-mount
utility faucet
❏ Faucet: 8340.243 same as above
with vacuum breaker
❏ Faucet: 8341.076 same as above
with vacuum breaker and stops in shanks
❏ Alternative Faucet
❏ Trap Standard: 7798.030 cast iron “P” trap
standard to wall and strainer for 3” iron pipe
❏ Trap Standard: 7798.020 cast Iron “P” trap
standard to wall and strainer for 2” iron pipe
NOTES:
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
FITTING AND TRAP STANDARD NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances
established by ANSI Standard A112.19.1
These measurements are subject to change or cancellation. No responsibility is assumed for use
of superseded or voided leaflet.
FINISHED WALL
HANGER
C/L OF
SPOUT
BRACE
14
(356mm)
8
(203mm)
9
(229mm)
3 REF.
(76mm)
1
(25mm)
11-1/4
(286mm)
15 REF.
(381mm)
24
(610mm)
42-1/4
(1073mm)
26-1/4
(667mm)
10-1/4
(260mm)
20-1/2
(521mm)
2
(51mm)
5
(127mm)
10-1/2
(267mm)
9
(229mm)
1/2 COLD
1/2 HOT
FINISHED
FLOOR
2 OR 3 N.P.T. NIPPLE
AND FLANGE
NOT FURNISHED
6
(152mm)
Revised 5/03