Installation Guide

14 - EN -
5. Install the remote control unit
CAUTION
• Insert each battery so its positive
pole touches a positive connector
in the battery compartment and its
negative pole touches a negative
connector.
CAUTION
• Leave enough space above the
top of the remote control unit to
allow the unit to be removed and
replaced.
(2) Position the bracket on the wall
in the location you chose for
the remote control unit. Mark the
location of the mounting holes on
the wall. Fasten the bracket to the
wall, drilling holes and using the
fasteners appropriate for the wall
material, as described below.
(1) Open the back cover of the
remote control unit and insert the
2 size AA batteries.
If mounted in plywood paneling
0.20 in. (5 mm) or greater in
thickness:
Fasten the bracket to the wall with the
mounting screws.
100mm
200mm
Mounting Screw
Bracket
Battery
Back Cover