Instructions / Assembly

25 - EN -

Night light

Remote Control signal settings when multiple units are installed side by side
SpaLet
®
seat is equipped with night light, which can be enabled when necessary.
1. To turn on night light, press [Night Light] button on the remote Control.
2. To turn off night light, press [Night Light] button on the remote Control.
When installed side by side, other SpaLet
®
seat may receive signal from remote control of this product
and take that action. In this case, please change the signal used by the remote control.
1. Change transmission signal of remote control
(1) Remove batteries of remote control
(2) According to signal table in the following figure, press corresponding button while installing batter-
ies, and hold for 6 seconds. (Signal 6, signal 7 may be 20 seconds.)
(3) When transmission signal changes, battery indicator of remote control will flash accordingly.
(Flashing times of battery indicator vary with the corresponding signal change.)
Signal number Operation switch Flashing times of battery indicator
Signal 1 Water Temp 1 time
Signal 2 Seat Temp 2 times
Signal 3 Power Saving 3 times
Signal 0 Nozzle Cleaning 4 times
Signal 4 Spray Strength + 5 times
Signal 5 Spray Strength
- 6 times
Signal 6 Cleansing 7 times
Signal 7 Bidet 8 times
Factory setting is [Signal 0]
2. SpaLet
®
seat receiving signal change
(1)Temporarily unplug the power plug of the SpaLet
®
seat that needs to change signal
(2)Then, insert the power plug, and press Stop button continuously for more than 10 times within 10
seconds.
[Night Light]
Other convenient functions